Stagg 15 GA DR User manual

BACK PANEL:
WARNING: This amplier must be earthed. Please check that the supply voltage details given on the
rating label (located on the rear panel) are in accordance with your electricity supply.
1 POWER FUSE: In the event of the power fuse having to be replaced, rst unplug the power cable
from the mains outlet. Then remove the fuse cover and replace the power fuse with one of the same type
and value. Never plug the power cable back into the mains outlet without the fuse cover. When powering
on the amplier, if the power fuse blows up again, go to a suitable service centre for repair.
MAINS CABLE: This amplier features a power cable with a moulded-on plug. If the socket outlets in the
home are not suitable for the plug supplied with this amplier, use an appropriate plug adapter that can
handle the power required for this amplier. In case the power cable or plug is damaged, unplug it in a
safe way from the mains outlet and go to a suitable service centre for replacement.
Features and Specications are subject to change without notice.
FRONT PANEL:
1. INPUT: Plug your guitar in here. We recommend that you always use a high-quality shielded guitar
cable to prevent any background noise interference or unwanted feedback.
2. (Overdrive) GAIN: This control determines the distortion intensity of the amplier’s overdrive setting.
Adding GAIN will make your guitar sound more distorted.
3. (Overdrive) SWITCH: This switch activates the amplier’s built-in overdrive function, which adds
distortion to the signal.
4. (Clean) VOLUME: This control determines the amplier’s overall output volume.
5. TREBLE: This control determines the level of high frequencies in the output signal. Adding TREBLE will
make your guitar sound brighter and sharper.
6. MID: This PARAMETRIC control determines the level of middle frequencies in the output signal. Adding
MID will make your guitar sound rounder and fuller.
7. BASS: This control determines the level of low frequencies in the output signal. Adding BASS will make
your guitar sound warmer and heavier.
8. DIGITAL REVERB: This is the reverb intensity control. This controls the amount of reverb that is added
back to the original dry signal. Adding DIGITAL REVERB will produce a reverberation effect in your guitar
sound, as though you were playing in a large hall. A little can go a long way in adding that special depth to
your sound. If engaged, the reverb is always active in either overdrive or clean mode.
9. CD/MP3 INPUT: This is a line level 1/4” (Ø 6.3 mm) stereo jack into which an MP3/CD/Tape player
may be connected.
10. PHONES: This is a 1/4” (Ø 6.3 mm) standard jack output to connect the headphones. When
headphones are connected, no sound is produced from the speaker.
11. POWER LED: When this red LED is lit, the amplier is ready to work. When it is off, it means the
amplier is powered off.
12. POWER: This switch turns the amplier on or off.
2 3 USER’S MANUALSUSER’S MANUAL 15 GA DR 15 GA DR
1
1 2 3 4 5 6 7 8 1210911
TECHNICAL SPECIFICATIONS
Max. Rated Power / Loudspeaker 15 Watts RMS @ 8 Ohms load / 6.5” speaker
Frequency Response 80 Hz to 15 kHz
Total Harmonic Distortion 0.8% (Clean Mode)
Signal to Noise Ratio - 55 dB @ max Rated Power
Input Impedance 220k Ohms
Power Consumption 20 Watts max
Maximum Input Level 45 mV (RMS)
Maximum Gain 42 dB (@ 1kHz)
Dimensions (H x W x D) 31 x 35 x 19 cm / 12.2 x 13.8 x 7.5 in.
Weight 6.3 kg / 13.9 lbs

RoHS
compliant
4
USER’S MANUAL 15 GA DR
INSTRUCTIONS FOR USE:
Plug the mains lead into a suitable power socket and connect your instrument to the input socket of the
amplier with a suitable guitar lead (this lead is not supplied with the amplier, but is normally supplied
with the electric guitar). Finally, press the Power Switch to the ON position, the power LED will light up and
your amplier is ready for use.
IMPORTANT SAFETY INSTRUCTIONS:
READ AND KEEP THESE INSTRUCTIONS HEED ALL WARNING.
• If, after you have followed the instructions outlined above, your amplier fails to function, please contact
your dealer. Under no circumstances should the amplier be opened. Leave all servicing to qualied
personnel.
• Electrical appliances must never be used in conditions of high humidity or heat.
To prevent any risk of re or electric shock, never spill or splash liquids on the amplier.
Should this happen, unplug the power cable from the mains outlet immediately.
• We would like to draw your intention to the instructions printed on the notice attached to the back of
the amplier.
• Exposure to extremely high noise levels may cause permanent hearing damage (especially when using
headphones). Please use this amplier responsibly for you and your neighbourhood.
MARKING & CONFORMITY:
1. The CE mark on this product means it conforms to the EMC Directive (89/69/EEC), CE marking Directive
(93/68/EEC) and Low Voltage Directive (72/23/EEC).
2. The «Crossed-out Wheeled Bin» is to draw your attention to the WEEE (Waste Electric & Electronic
Equipment) Directive (2002/96/EC). It means this apparatus must be collected separately for recycling.
3. «RoHS compliant» means this device conforms to the Directive (2002/95EC) on the restriction of the use
of certain hazardous substances in electrical and electronic equipments, such as: Mercury, Lead, Cadmium,
Hexavalent Chromium, Polybrominated Buphenyl (PBB) and Polybrominated Diphenyl Esthers (PBDE).
USER’S MANUAL
DISTRIBUTOR / DEALER
EMD Music 01-2008-UK
GUITAR AMPLIFIER
wITH DIGITAL REvERB - 15 GA DR