3
ENGLISH
Package Contents
The package contains:
2 Axle Standsa
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Description (Fig. A)
WARNING: Never modify the axle stand or any part of it.
Damage or personal injury couldresult.
1 Saddle
2 Upper column
3 Lower column
4 U-Shaped load pin
5 Locking pin
6 Locking holes
Intended Use
This axle stand is intended to safely support one end of a
vehicle.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This tool is not intended
for use by young children or infirm persons without
supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.
OPERATION (Fig. B, C)
Supporting a Load
WARNING: ENSURE THAT BOTH ENDS OF THE
U-SHAPED LOAD PIN ARE ALWAYS FULLY INSERTED
THROUGH EACH OF THE LOCKING HOLES ON THE
UPPER AND LOWER COLUMNS AND IS SECURED
USING THE LOCKING PIN. Damage or personal injury
couldresult.
1. Using a suitable jack, lift the vehicle so the axlestands can
be positioned into place.
2. Position the axle stand so that the load will be placed on the
centre of the saddle.
3. Lift the upper column upward to desired height and insert
both ends of the U-shaped load pin 4 into the locking
holes 6 through both the upper and the lower column.
4. Secure the U-shaped load pin with the locking pin 5 .
5. Slowly lower the vehicle onto the stands. Ensure the load is
centred on the saddle.
6. Ensure vehicle is secure and stable before working around or
under the vehicle.
Lowering Load
1. Using a suitable jack, lift the vehicle clear of the axlestands.
2. Remove stands from under the vehicle.
3. To lower stands, the locking pin from the U-shaped load pin.
Remove both ends ofthe U-shaped load pin 4 from the
locking holes 6 .
4. Follow procedures of jack operation to lower vehicle.
ASSEMBLY AND OPERATION (Fig. B)
Pre-Use Inspection:
• Prior to each use, visual inspection shall be made to the
device by checking for abnormal conditions including
cracked welds, leaks, and damaged, loose, or missingparts.
• Consult the vehicle owner’s manual to determine the
location of lift points.
• Other inspections shall be made per product
operatinginstructions.
• This device shall be inspected immediately if the device is
believed to have been subjected to an abnormal load or
shock. It is recommended that this inspection be made by a
manufacturer’s authorized repair centre.
• Owners and/or operators should be aware that repair of this
equipment may require specialized knowledge and facilities.
It is recommended that an annual inspection of the product
be made by a manufacturer’s authorized repair facility and
that any defective parts, decals, or safety labels or signs be
replaced with manufacturer’s specified parts.
• Be sure to set the vehicle in park with the emergency brake
on and chock the unlifted wheels of the vehicle.
Storage
Store in a dry location on a level surface.
1. For easy storage, move the upper column to desired height
and insert both ends of the U-shaped load pin 4 into
the locking holes 7 through both the upper and the
lower column.
2. Secure the U-shaped load pin with the locking pin 5 .
• Be sure that the vehicle and the jack are on a hard,
levelsurface.
Assembly:
The axle stands come pre-assembled with an adjustable upper
column inserted into the lower column.
