2.1 Battery/Charger
Connect with computer or charger through USB cable.
Note: charge time is about 2-3 hours. Red light is on
when charging and is off when fully charged.
2.2 Power on/off
2.2.1 Power on: Hold the MFK for 2 seconds, until you
see blue LED flashing, to power on the device. You will
then hear the tone to indicate "power on",
2.2.2 Power off: In standby or music play mode, hold
the Multi-function button for 3 seconds, you will see the
red light is on for 2 seconds. You will then hear the tone
to Indicate "power off".
2.3 Volume Adjust
2.3.1 Volume Up: Press Vol + repeatedly to Increase
the volume.
2.3.2 Volume Down: Press Vol - repeatedly to decrease
the volume.
2.4 Pairing and Connection
A. With the device switched off, press the MFK for
2 seconds until the red & blue LEDs flash alternately.
You will hear the tone to Indicate the device is enter
pairing mode.
B. Activate Bluetooth function of your mobile phone and
other device. C. Connect with your Bluetooth device(s)
1) Add or search device: when "SWS"appear, confirm
your selection. 2) Input password: 0000 if required.
2.5 Calling Operation
2.5.1 Calling: A. Answer the call: Short press the MFK
to answer an incoming call. B. Reject the call: Press
and hold the MFK for 2 seconds to reject the call. C. End
a call: After calling, short press the MFK to end the call
or end the call on the phone. D. Redial: Short press the
MFK twice to redial the last call. E. Microphone mute:
Short press Vol+ and Vol- once, to make themicrophone
mute. F. Before making a call please mate sure the
Microphone is not blocked.
2.5.2 Voice Dialing: (This function needs the support
of the mobile phone) In standby mode. Short press Vol+
& MFK once. You will hear the tone to indicate voice
dialling.
3. Trouble Shooting
3.1 Volume is not high enough
3.1.1 Increase the volume of mobile phone/device
or speaker volume.
3.1.2 Ensure that the device has been charged.
3.2 Hearing Distortion
3.2.1 Lower Speaker, Mobile phone/device volume.
3.2.2 If battery is low, please charge it.
3.3 Cannot be paired with Bluetooth device
3.3.1 Make sure that your mobile phone/device
Is compatible with Bluetooth.
3.3.2 Attempt to pair with the device again
(refer to 2.4 Pairing and connection).
3.4 Signal loss or distortion
3.4.1 Move Speaker closer to the mobile phone/device,
3.4.2 Ensure the device is fully charged,
3.4.3 Power off the speaker. Mobile phone &
Device,then restart again.
4. Safety Information
For the safety of yourself and property, please read the
following safety warnings and reminders. The
manufacturer will not be liable to you or any third party
if improper use or misuse of the product results in any
injury and assumes no responsibility for any loss.
4.1 Fire and shock hazards
4.1.1 Do not put your speaker to any liquid, moisture or
rain which strength is more than IP65 level.
4.1.2 Do not drop, disassemble, open, crush, bend,
deform, puncture, shred, microwave, fire, defaced, or
insert something into the speakerphone. Those actions
will result in electric shock.
4.1.3 We recommend using cloth to wipe the speaker.
4.1.4 Do not expose the speaker in too high or too low
temperature.
4.1.5 Do not expose the speaker under the direct
sunlight for a long time.
4.1.6 Do not put the speaker near the place, such as fire
stoves, candles or fireplace.
4.2 Battery/Charger Damage
4.2.1 Do not drop the speaker into the fire, Battery
explosion will cause personal injury or death.
4.2.2 Please charge the speaker under the manual
guide.
4.2.3 Do not attempt to disassemble or forcibly take
apart the built-in battery, these actions may cause
electric shock.
Manufactured under license by ADAR GENERALE TELECOM SERVICE Stanley®
is a registered trademark of The Stanley Works or ib affiliates and is used under
license.
