Stanwood Tumbling Flower Spinner User manual

1
Stanwood®Tumbling Flower Spinner Assembly Instruction
Installaon: Pole Anchoring
Step 1
Gather these parts, one pole with beveled edge, three sup-
port stakes from the box .
Step 2
Hammer the main pole into the
ground using a Rubber Mallet unl
the black line touches the ground
(about 1 .
deep).
Step 3
Slide a support stake into
the main pole
and hammer it into the
Step 4
Slide a second support stake into the main
pole. Posion it ~1200 degrees away from
the rst stake and hammer it into the
ground.
Step 5
Connect the three pole
secons together.
Copyright © Stanwood Imports & Oriental Touch LLC
Slide a third support stake on to the main pole. Posion it
evenly away from the rst two stakes and hammer it into the
ground.
*Check all screw ghtness periodically , and ghten if needed
* We recommend you use blue Locte thread locker if in windy area

2
Installaon: Tumbling Flower Spinner
Step 6
Copyright © Stanwood Imports & Oriental Touch LLC
Step 7
Match the numbering on the
stems and the hub and align
according to the picture g A.
Pay close aenon to numbering “6” and “9 ” on the stem, do not mismatch.
Align the hole on the stem with
the hole on the hub g B
Screw in manually as ght as possible
g C, DO NOT USE POWER TOOL!
Arrange the ower stems according to the numbering on the brass hub
Finished wheel assembly g D
Repeat on the other wheel
AB
CD
*Check all screw ghtness periodically , and ghten if needed
* We recommend you use blue Locte thread locker if in windy area

3
Step 8
Place the assembled
wheel with the
numbering facing inside
towards the brass T-Bar.
Repeat on the other side
Screw on the mushroom caps
Step 7 cont.
Finished wheel assembly
Step 9
Slide the brass T-bar onto the pole
Step 10
Finish setup
Need help?
Scan the QR code
contact us at
[e-mail] or
*Check all screw ghtness periodically , and ghten if needed
* We recommend you use blue Locte thread locker if in windy area