Steelcraft AX910 series User manual

06 03
NOTES
www.britax.com.au www.britax.com.au
CARE AND MAINTENANCE
Regularly inspect and maintain your product to ensure the freedom of movements of the
locking devices and security of components.
To prolong the life of your nursery product keep it clean and do not leave it in the direct
sunlight for extended periods of time.
Removable fabric covers and trims may be cleaned using warm water with a household
soap or a mild detergent. Allow it to dry fully, preferably away from direct sunlight.
HELPFUL HINT: When using your rocker at the beach, completely clean it afterwards to
remove any sand or salt from the unit.
DO NOT DRY CLEAN, OR USE BLEACH.
Do not machine wash, tumble or spin dry, unless care labelling on the product permits
these methods.
Non removable fabric covers and trims may be cleaned using a damp sponge with soap
or mild detergent. Allow it to dry completely before folding or storing it away.
In some climates the covers and trims may be affected by mould & mildew. To help
prevent this occurring, do not fold or store the product if it is damp or wet. Always store
the product in a well ventilated area.
To maintain the safety of your nursery product, seek prompt repairs for bent, torn, worn
or broken parts. Use only parts and accessories approved by Britax.
Always check parts regularly for tightness of screws, nuts and other fasteners -
tighten if required.
THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE.

04 05
www.britax.com.au www.britax.com.au
1. ADJUST THE CANOPY
AAdjust the canopy to the desired position by either
pushing up or pulling out.
Note: The crotch strap and the lower harness
straps also have a webbing end. Ensure webbing
end sits flat against the slot moulding as shown in
illustration A.
5. TO USE THE HARNESS
APlace baby in the rocker and position the crotch
strap between baby’s legs. Thread the lap strap
buckles through the crotch strap and engage.
WARNING: USE CROTCH STRAP AT ALL
TIMES. NEVER USE LAP BELT ONLY.
ADJUST THE LAP BELT TO A FIRM BUT
COMFORTABLE FIT.
6. TO ADJUST THE TOY BAR
AFirmly grip the top frame of the toy bar and
move to desired position.
2. TO ADJUST THE SEAT ANGLE
ATurn the knobs located on both sides of the
rocker anticlockwise to loosen. One full turn
is sufficient.
BThe seat angle is adjustable to three recline
positions, tilt the seat to the desired position,
then turn the knobs clockwise to lock the seat
into position.
3. TO ATTACH TOY BAR AND TOYS
AAttach the toy bar by fitting the mouldings to the
base of the canopy frame.
BAttach toys to the bar by fitting the strap located
at the top of the toy bar through the loop in the
top of the toy.
4. TO STABILISE THE ROCKER
ALift the rocker at the rear, then rotate the rear
leg stand back.
BTo revert to the rocking position, rotate rear
leg stand forward.
BRelease the lap strap buckle by squeezing
the buckle prongs until released.
Note: For baby’s comfort, slide buckle into the crotch strap.
7. TO FOLD THE ROCKER
AFor compact storage, fold canopy and toy bar
back, release the locking catch, then rotate the
bottom rail to the front of the rocker.