Sternberg Lighting LUNARIA LU300 User manual

[LU300 –LUNARIA Bollard], Installation Instructions, Revision A
Page 1 of 4
Installation Instructions
Product: LU300 - LUNARIA Bollard
Effective Date: 10/14/2019
Part Description: Customer Installation Instructions
WARNING: To avoid fire, shock or death, turn off and lockout power before performing any
maintenance.
CAUTION: This Fixture must be wired in accordance with the National Electric Code (NEC)
and all applicable local codes. Proper grounding is required. A qualified electrician must do
all work.
Step 1: Unpack Bollard.
Handle with care. Recycle the empty
packaging.
Step 2: Remove three set screws
from base to separate it with top of
bollard and save them.

[LU300 –LUNARIA Bollard], Installation Instructions, Revision A
Page 2 of 4
Step 3: Carefully lift the top of
bollard - UP then TWIST in 10
and UP as shown and put to the
side.
NOTE: Do not disconnect wires with
driver assembly.
Step 4: Remove the LED driver-
bracket assembly and save the two
sets of screws and washers.
Step 5: After the anchor assembly
has been installed (refer to anchor
bolt templates), mount the base.
NOTE: Make sure base is level on all
sides.

[LU300 –LUNARIA Bollard], Installation Instructions, Revision A
Page 3 of 4
or
Step 6: Install the LED driver-
bracket assembly back in to the base
with existing two sets of screws and
washers.
Wiring Diagram
Step 7: Connect supply wires to the
driver assembly according to the
wiring diagram.

[LU300 –LUNARIA Bollard], Installation Instructions, Revision A
Page 4 of 4
Step 8: Return the top of bollard
onto the base –slide DOWN then
TWIST in 10and DOWN as
shown.
NOTE: Confirm assembly is level.
Step 9: Secure with three saved set
screws and fully tighten.
FINAL VIEW
Revision History
Rev
Description of Revision
Release Date
Manufacturing
Engineer
Design Engineer
A
Initial Release
10/14/2019
Grant Burton
N.KOZYREVA