Stone Forest PFS-TD-24 MT Series User manual

PFS-TD-24-xx-MT (formerly PFS-TDTRY-24)
PFS-TD-36-xx-MT (formerly PFS-TDTRY-36)

1. Usingwhiteglovesprovided,carefullylayoutallbrassornickelfittings
onaprotectedsurface.Someassemblywillberequiredusingthe
includedallenwrench.



2.Startwiththefrontlegs.Thesecomepre‐assembledwiththebottomcollars
settosupportthemetaltray8”fromtheground.Theheightofthecollarscan
beadjustedusingthesetscrewtosuitdesireddesignandspace.Iftheyare
moved,theincludedwoodblockspacerswillnolongerbeaccurate.



3. Carefullyslidethelegsthroughthemetaltrayunitfromthebottom.
We’veincluded2pcsof2x2”woodcutto8”tohelpwiththeinitiallocationsupplied2x2”s
ofthedraweronthewall.



4.Movethetrayandlegsintoposition.Levelthebackedgeofthemetaltray.
Oncelevel,usethesuppliedscrews(andanchorsifneeded)toattachsupplied2x2”(1of2)
thetraytothewall.Oncethebackisanchoredtothewall,youcantwistthe
frontfeettohelplevelfronttoback.



5.Setthereturnarmsontothefrontlegs.Verifythatthearmsaresquare
andlevelbeforemarkinganddrillingholesforthebrassescutcheon.
Ifdrillingintowoodblockingorstuds,pleasepre‐drilltheholeswith
a7/64”bit.Thiswillhelpwiththeinstallationofthesofterbrassscrews.
Ifgoingintodrywall,usethesuppliedanchorsandpre‐drillusing3/16”bit.


6.Installsinktopandbracketaccordingtothesinkmodel.Thestonesinksare
counterboredontheundersidetoacceptthetop3/8”ofthefrontlegs.The
collarsdirectlyunderthesinksdonotsupportanyweight.Thesecanbe
adjustedupagainstthesinkbottomwhenyouaredonewiththefinalassembly.