Stovetop Firestop PLUS SENSOR User manual

FIRE SAFETY
MANUFACTURERS INFO
WARNING CAUTION
Designed & Manufactured
by WilliamsRDM in Texas
Designed solely for suppressing
stove top grease fires in
indoor residential kitchens using no more
than 1” of oil before food is added.
Contents: Potassium Bicarbonate
For storage and disposal information,
or to learn more about StoveTop FireStop,
please visit our website at www.STFS.com,
or call 1-888-616-7976.
• Keep away from children.
• Avoid exposure to suppressing powder if you
wear contacts, or have a respiratory illness or
skin allergies.
• Contents may be harmful if swallowed.
• Suppressing powder is non-toxic but could
cause skin irritation. In case of contact with
powder, flush from affected area with water.
• If irritation persists, contact a physician
immediately.
• Discard product after activation.
• Discard product if dropped or damaged.
• Do not clean unit.
679-S-35 Rev — 05/2017
AUTOMATIC FIRE SUPPRESSION FOR GREASE FIRES
ON INDOOR RESIDENTIAL STOVE TOPS
(CLASS K)
www.STFS.com
• Not intended for cooking with more than 1” oil
depth before food is added.
• Not recommended for gas stoves; powder may
extinguish burner flame on a gas stove top
• If safe, turn burner OFF immediately after
activation.
• Reignition is possible.
• When suppressing powder comes in contact
with fire, it may briefly flare and/or cause
grease to splash. This is a normal and
temporary reaction.
• This product may not suppress all stove top
fires.
Read this user manual carefully prior to installation
FCC NOTICE
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
NOTICE
• Failure to remove or replace by the “remove
or replace before” date, as shown on the
product label, could diminish the effective-
ness of the product.
• Primary activation method is through
electronic sensors.
• At time of activation, a loud “POP” will
occur, followed by 3 long, repeating
tones. This is normal and meant to alert
occupants, if present.
• Device is equipped with a fuse that works
as a secondary activation method in case
of dead batteries.
• Replace batteries as required to ensure
optimum performance. Do not mix old and
new batteries. It is recommended that you
not mix brands.
WilliamsRDM, Inc. (“WRDM”) warrants this StoveTop FireStop®
product against defects in material or workmanship for the time
periods and under the terms set forth below. Pursuant to this
Limited Warranty, WRDM will, at its option, (i) repair the product
using new or refurbished parts or (ii) replace the product with a
new or refurbished product. For purposes of this Limited Warranty,
“refurbished” means a product or part that has been returned to its
original specifications. In the event of a defect, these are your
exclusive remedies.
WRDM warrants to the original retail purchaser all WRDM products
for a period of one (1) year against defective material and faulty
workmanship. Any unit found to be defective during the warranty
period will be repaired if possible, or replaced free of charge upon
the buyer’s prepaid return of the defective unit—only after receipt
of an official Return Material Authorization (RMA) number. Proof of
retail purchase is required. This warranty gives the buyer specific
legal rights which may vary by state (or country.)
THE FORGOING WARRANTY IS MADE IN LIEU OF ALL OTHER
WARRANTIES WITH RESPECT TO THIS PRODUCT, INCLUDING
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE—WHICH ARE HEREBY
DISCLAIMED. THERE ARE NO IMPLIED WARRANTIES WHICH
EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. NO
PERSON IS AUTHORIZED TO GIVE ANY OTHER WARRANTY, OR
TO ASSUME FOR WRDM ANY OTHER LIABILITY IN CONNECTION
WITH THE SALE OR INSTALLATION OF ITS PRODUCTS.
REPLACEMENT OF THE PRODUCT WILL BE THE SOLE REMEDY
WITH RESPECT TO ANY LOSS OR DAMAGE TO PROPERTY.
BUYER IS NOT RELYING ON SELLER’S JUDGMENT REGARDING
BUYER’S PARTICULAR REQUIREMENTS AND BUYER HAS HAD
AN OPPORTUNITY TO INSPECT THE PRODUCT TO BUYER’S
SATISFACTION. UNAUTHORIZED SERVICE OF ANY KIND
INVALIDATES ALL WARRANTY PROVISIONS.
This Limited Warranty covers only the hardware components
packaged with this product. It does not cover technical assistance
for hardware. Any parts or product replaced under this Limited
Warranty will become the property of WRDM.
LIMITATION ON DAMAGES: WRDM SHALL NOT BE LIABLE FOR
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING
BUT NOT LIMITED TO ANY SUCH DAMAGES FOR ANY BREACH
OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT.
Instructions: To obtain warranty service, you must deliver the
product, freight prepaid, in either its original packaging, or
packaging affording an equal degree of protection, to WRDM’s
specified manufacturing facility.
This Limited Warranty only covers product issues caused by defects
in material or workmanship during ordinary consumer use; it does
not cover product issues caused by any other reason, including but
not limited to product issues due to commercial use, acts of God,
misuse, limitations of technology, or modification of or to any part
of the WRDM product. This Limited Warranty is invalid if either the
factory-applied work order number or date code has been altered
or removed from the product. This Limited Warranty is valid only in
the United States.
For StoveTop FireStop customer service:
go to www.STFS.com or call 1-888-616-7976.
LIMITED WARRANTY
• Unattended cooking is the leading cause of
fires in the kitchen. Many injuries occur when
occupants attempt to fight the fire themselves.
• Never leave anything cooking on the stove top
unattended! If you have to leave the kitchen
—even for a short time— turn off the stove.
• Never leave home or fall asleep while you are
cooking.
• Never pick up a flaming pan. You may be
burned, or if the pan is dropped, flames may
quickly spread to other flammable areas.
• Never use water to fight a grease fire! A violent
explosion may result. Wet dishcloths or towels
are also dangerous.
• Always follow National Fire Protection
Association (NFPA) guidelines for proper
cooking safety. Visit www.nfpa.org.
© 2017 WilliamsRDM, Inc. All rights reserved. StoveTop FireStop, the StoveTop FireStop logo, STFS, the STFS Plus logo and design graphics are either registered
trademarks or trademarks of WilliamsRDM, Inc. in the United States, and/or other countries. Model No. 679-S-3A. Patent info at www.STFS.com/patents.
USER MANUAL
The Next Evolution in StoveTop FireStop®

SOUND MEANING CONDITION CYCLE ACTION
ALERTS
3 long tones Device has detected a fire and
deployed suppression powder Alarm
Repeats every 1.5 seconds
until batteries run out or
are removed
Leave dwelling immediately,
then call 911
1 short tone Low Battery Low Battery
Repeats every 60 seconds
until batteries run out or
are replaced.
Replace old batteries with
two (2) new, 1.5V alkaline,
N-cell batteries
2 short tones Device has detected an error
within the sensor board Fault Repeats every 60 seconds until batteries run out
Go to STFS Plus Sensor
Troubleshooting Section at
www.STFS.com
TESTING
3 short tones Initial activation by pulling tab,
or batteries have been replaced Power On
Once when tab is pulled,
and each time batteries are
replaced.
Device is powered on and
working properly
1 continuous tone Hold down self-test button for
more than 3 seconds Self Test Continuous until button release
Device has self-tested, and is
working properly
BATTERY REPLACEMENT
INSTALLATION ACTIVATION
TESTING
(3)
(2)
1) Must have 22-32” (56-81 cm) between surface of cooktop and
mounting point in range hood. Clean and dry areas in range hood
where both magnets will attach.
2) Position canisters in range hood at the midpoint between the center of
front and back burners on each side.
3) Raise canisters to the spot directly above in range hood.
4) Place the enclosed decal where it can be seen in the ventilation hood.
If the magnet does not attach, go to www.STFS.com to order an
alternative mounting kit.
1) Use #2 Phillips head screw driver to unscrew the
three (3) small screws from the sensor board.
2) Remove the sensor board, taking care not to
damage or disconnect the wires.
3) Properly dispose of the existing batteries.
4) Replace with two (2) new, 1.5V alkaline N-cell,
batteries. Do not mix new and old batteries.
5) Fold the wires back into place, taking care
not to damage the wires.
6) Reattach the sensor board with the three (3) small
screws, and reinstall per installation instructions.
Do not tamper with any sensors, or any other
parts of the product or you risk device malfunction
and voiding manufacturer’s warranty.
1) To test the device, hold Test button for more than 3 seconds until a
tone is heard.
2) When the button is released, the tone will stop.
1) Pull out the red tab to activate the product. The product should emit
three (3) short tones, one time.
2) If no sound is heard, proceed to TESTING section and/or BATTERY
REPLACEMENT sections.
See chart below for explanation of additional alerts.
(2)
(1) (2)
(1)
(4)
(5)
(2)
(1) (3)
(6)
(4)
(1)