manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. STREET WISE
  6. •
  7. Remote Starter
  8. •
  9. STREET WISE SWPB2 User manual

STREET WISE SWPB2 User manual

Please READ & UNDERSTAND these instructions carefully before operating this
device, and retain for future reference.
It is recommended to charge the
unit for at least 3 hours before
any use.
Lancashire
BL9 9NB
Next Generation
Emergency Jumpstarter
& Portable Power Bank
12V -
300Amp
A POWERFUL but compact 300Amp-(peak) Emergency
Jumpstarter for most 12V vehicles. PLUS a Power Bank that
also provides HOURS OF PORTABLE POWER for smart phones,
tablets and much more when out and about!
RoHS
COMPLIANT
Emergency Jumpstart & Power Bank contents:
Emergency Jumpstarter & Power Bank
12V battery clips with countercurrent protection (protects jumpstarter & vehicle battery).
USB charge cable with 4 built-in assorted adaptors.
240V mains plug.
12V in-car charging plug.
Streetwize Accessories:
Sales enquiries: [email protected]
Technical enquiries: [email protected]
www.streetwizeaccessories.com
Warnings: The power bank will generate heat when charging. Use it in a well ventilated
area when charging. Keep the power bank away from heat sources,
direct sunlight, humidity, water or other liquids.
Do not operate the power bank if it is wet or damaged to prevent electrical shock,
explosion and/or injury. Improper repairs of this device may place the user at risk.
Do not use the power bank with wet hands.
Keep the input ports free from dust, lint, etc. which prevents good connections.
Do not use this unit for anything other than its intended use.
The power bank is not a toy. Keep out of reach of children.
Do not charge under pillows, blankets. Do not store in a car during hot weather.
Short-circuiting a Li-ion battery can cause it to ignite or explode. Never open a Li-ion
battery’s casing. Li ion batteries contain safety devices that protect the cells inside from
abuse, if damaged these can cause the battery to ignite or explode.
Do not charge the power bank and charge an electronic device at the same time.
This will shorten the power bank’s battery life.
THE MANUFACTURER AND SUPPLIER HOLDS NO RESPONSIBILITY FOR DAMAGE
CAUSED BY INCORRECT OR IMPROPER USE OF THE PRODUCT. PLEASE READ
AND RETAIN THE INSTRUCTIONS.
The WEEE symbol on this product means that this product should be ethically
dismantled or recycled to minimise environmental impact. Please check with your local
authority for more information.
IMPORTANT: ADDITIONAL SAFETY INFORMATION: This Jumpstarter & Power Bank is
NOT intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they are supervised or
have been given instruction concerning use of the Jumpstart & Power Bank by a person
responsible for their safety.
SWPB2 Manual AW.qxp_Layout 1 13/05/2016 09:16 Page 1
Please note that some Apple®products may not charge if a non-Apple®charging
cable is used. Charging products is done entirely at the users own risk.
Constant Current/Constant Voltage 15V 1A
Please read & understand this entire maunal before attempting to use the product.
over 80°C or below -25°C.
12. It is recommended if the power bank is left unused for a period of time,
to recharge the unit every 3 months.
SWPB2 Manual AW.qxp_Layout 1 13/05/2016 09:16 Page 3
Function on Smart Battery Cable
1) Reverse polarity connection: Solid Red LED with fast 2 short beep.
2) Short-circuit protection: Solid Red LED with long beep
(Beeping as 3.3Hz Frequency).
3) Over-heat protection: Solid Red LED with long beep
(Beeping as 2Hz Frequency).
4) Over-discharging protection: Solid Red LED with 2 short beep.
5) Green/Red LED flashing: Searching for status connection.
6) Green LED: Correct connection after one beep.
Do not use any charger cable other than those specifically provided
with the Jumpstarter/Powerbank for jumpstarting or charging.
SWPB2 Manual AW.qxp_Layout 1 13/05/2016 09:16 Page 5
DO NOT crank the engine for more than 4 continous seconds while the unit is
connected to the battery. It is always recommended to jump start a vehicle with
a full charge 4 LED’s. NEVER try to jumpstart with less than 3 LED’s showing.
If the engine fails to crank or start, after a number of tries, there may be a
problem other than a discharged battery.
Charging
230/240V
SWPB2 Manual AW.qxp_Layout 1 13/05/2016 09:16 Page 7

Popular Remote Starter manuals by other brands

Code Alarm CA 5051 installation guide

Code Alarm

Code Alarm CA 5051 installation guide

Auto Page RF-1055KE Operation manual

Auto Page

Auto Page RF-1055KE Operation manual

NOCO Genius Boost HD GB70 user guide

NOCO Genius

NOCO Genius Boost HD GB70 user guide

Stanley JS900CS instruction manual

Stanley

Stanley JS900CS instruction manual

MEGATRONIX CP 500 quick start guide

MEGATRONIX

MEGATRONIX CP 500 quick start guide

Topdon JUMPSURGE 3000 user manual

Topdon

Topdon JUMPSURGE 3000 user manual

NexPow T11F user manual

NexPow

NexPow T11F user manual

Young Shin Electronics R1800-900FM user guide

Young Shin Electronics

Young Shin Electronics R1800-900FM user guide

ProStart ProStart CT-3360 user guide

ProStart

ProStart ProStart CT-3360 user guide

AutoLoc KL800 User guide and installation manual

AutoLoc

AutoLoc KL800 User guide and installation manual

Prestige APS-57 installation manual

Prestige

Prestige APS-57 installation manual

Schumacher SJ1290 user manual

Schumacher

Schumacher SJ1290 user manual

Chamberlain 877LM manual

Chamberlain

Chamberlain 877LM manual

Suaoki U7 user manual

Suaoki

Suaoki U7 user manual

Code Alarmr CA RS owner's guide

Code Alarmr

Code Alarmr CA RS owner's guide

Granit GA2500 user manual

Granit

Granit GA2500 user manual

Directed Electronics PS-3655E-FM user guide

Directed Electronics

Directed Electronics PS-3655E-FM user guide

Titan TS 131A owner's guide

Titan

Titan TS 131A owner's guide

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.