Striplox Mini 120 User manual

Page 1
10
Ø7mm ROUTER BIT
125
Installation Guide
Mini 120 - Metric
1
2
3
125
710
29
29
Ø100 x 4 BLADE
Hook
Key
19.5
124 7
1
23
45
Material High Strength Reinforced Nylon
Colour Black
Fixing Method Glue
Use a Ø7mm router bit to cut a slot in both substrates
where the Hook and Key of the Mini 120 is to be
mounted. Depth needs to be 10mm for each.
Set the depth stop to #20 and guide height for substrate
thickness. Plunge in 3 locations then repeat using the Mark-
Out Template, packing the guide 3mm to achieve a 7mm cut.
Apply Striplox Liquidlox 15 second cure adhesive to
both sides of the slot in each substrate. Visit joinlox.com/
striplox or call 1800 JOINLOX to nd out more about Striplox
Liquidlox and Mark-Out Template.
Mounting
To aid in the installation of the Key and Hook, start by
inserting one end in the slot then use a hammer or
mallet to tap the component ush into place. Ensure
centre lines on substrate align with centre mark on
Hook and offset distance relevent to the Key.
After glue is applied, insert Hook and Key into slot
until ush with substrate. Allow to dry as per glue
manufactures instructions.
Router Cut Option
Biscuit Cut Option
Striplox Liquidlox
Align Centre Marks
From Centre Mark
Align Mark and Face
53

Page 2
Remove locking tab on the Key if
you wish to create a disassemblable
joint. This is best done with a sharp
utility knife.
OPTIONAL
6
Striplox™ and Joinlox® are trademark and patent protected internationally.
Installation Guide Mini 120 - Metric V2.0
B
*C
B
A
Direction Indic. Load Capacity
A 200 kg
B 146 kg
*C 119 kg
• Tested using MDF and xed with glue.
• *C is in direction of lock-up.
Load Capacity
A
B
7
Assembly components remembering the Key only
needs to travel 1 pitch for full engagement. This is
detailed in steps A and B.
Before assembling the Striplox Mini 120, make note of
the locking tab on the Key. Leaving this tab in place will
prevent the unintentional unlocking of the joint.
XY
Align Marks
Note the offset of the lugs on the Key body, length X is
larger than Y. Insert the Hook into the Key with the longer
X end towards the face to be pushed during assembly.
To complete the assembly push the end of the
substrate (with X offset) until the Mini 120 is fully
engaged.
AB

19.2
124
7
7
125
57.2 C/C
To suit
125 cut wheel
10
7
125
10
General Dimensions
Mounting Dimensions
Striplox Mini 120
Rapid Assembly Systems
Mounting Data Sheet - Metric Version
All dimension in mm
Notes:
Groove detail typical for both Hook and Key halves. 1.
Key shown in groove. 2.
Option B - Router Cut Option A - Cutting Wheel
Striplox Mini 120 Mounting Data Sheet - Metric 2.1
Material High Strength Reinforced Nylon
Colour Black
Fixing Method Glue
STRIPLOX
TM
JOINLOX® ARE TRADEMARK AND PATENT PROTECTED INTERNATIONALLY
Option C - Biscuit Cutter
7
10
Hook
Key
125
58 C/C
Locking Tab
(Opt.)