SummerAire OLM SERIES User manual

USER MANUAL
OLM
SERIES
WARM AIR OIL FIRED FURNACE
ALL OLM SERIES FURNACES ARE AIR CONDITIONING READY !
NOTICE TO HOMEOWNER
THIS FURNACE SHALL BE INSTALLED BY A CERTIFIED INSTALLER AND
WHERE REQUIRED BY LAW, A LICENSED TECHNICIAN
Save These Instructions For Reference
Summeraire Mfg.
Peterborough, Ontario
K9J 7B1
FOR SERVICE CALL:
INSTALLATION INFORMATION
______________________________ _____________________________
Installing Contractor Telephone Number
______________________________ _____________________________
Unit Model Number Unit Serial Number
________________________________
Installation Date
NOTICE TO HOMEOWNER
IF YOUR SUMMERAIRE OLM SERIES OIL FURNACE HAS BEEN INSTALLED USING THE
APPROVED SS2C TJERNLUND SIDEWALL POWER VENTOR; IT IS YOUR
RESPONSIBILITY TO KEEP THE AREA AROUND THE VENT TERMINAL FREE OF ICE,
SNOW, AND DEBRIS
OCT., 2007R

2
OPERATING INSTRUCTIONS
CAUTION: THIS FURNACEIS APPROVED FOR FUEL OIL NOT HEAVIER THAN NO. 2
DO NOT USE GASOLINE, CRANKCASE OIL, OR ANY OIL CONTAINING GASOLINE
NEVER BURN GARBAGE, REFUSE OR PAPER IN THE HEATING UNIT.
NEVER LEAVE COMBUSTIBLE OR OTHER MATERIALS AROUND OR NEAR THE FURNACE.
IDENTIFY THE LOCATION OF YOUR BURNER / FURNACE POWER SWITCH
OIL BURNER OPERATING INSTRUCTIONS
• UseNo2furnaceoilONLY
• Donotusegasoline,crankcaseoil,oranyoilcontaininggasoline.
• Donotattempttostarttheburnerifexcessoilhasaccumulated,whenthefurnaceisfullofvapor,
orifthecombustionchamberishot.
• PresstheburnerrelayresetbuttonONLYONCE;iftheburnerfailstostart,callan
OilBurnerTechnician.
• Iftheoilburneristobeshutoffforanyperiodoftime,shuttheoilvalveOFFattheoiltank.
• Donotadjustortamperwiththefurnaceoranyofthecontrols
• Donotburngarbageorpaperinthisunit.
• Neverleavepaper,rags,orothercombustiblesaroundthefurnace.
• Onlyqualied,orwhererequiredbylaw,alicensedtechnicianshallset–upthisunitand
adjustcontrols.
• DONOTSTARTTHEOILBURNERUNLESSTHEBLOWERDOORISSECUREDINPLACE.
TO TURN THE BURNER OFF
• Turnthemainoilburnerswitchto“OFF“
• Setthethermostatasfarbelowroomtemperatureaspossible.
IF BURNER IS TO BE SHUT OFF FOR AN EXTENDED PERIOD.
• Turnmainoilburnerswitchto“OFF”.
• Closealloilsupplyvalves.
• Theheatingsystemshouldbecheckedandcleanedifnecessary.
Note: Always keep oil supply valve shut off if burner is shut down for an extended period of time.
BURNER FAILS TO OPERATE
Alwayscallaqualiedtechnician.
Thetroublemaybe:
• Raiseyourthermostatto5ºC(10ºF)abovepresentroomtemperature
• Makesureyour“OilBurner”powerswitchisinthe“ON”position
• Ifyouhearahumfromtheoilburner,andthemotorhasnotstarted,presstheresetbuttononthe
burnermotoronceonly.
• Blownfuse/“tripped”breakerinelectricalpanel
• Thermostatmaybesetbelowroomtemperature.
• Burnerrelay(combustioncontrol)mayhavetobe“reset”(pressresetonceonly)
• Oilvalvemaybeclosed.
• Oilsupplymaybetoolow.
• Blockeduesensor“tripped”
• Iftheoilburnerfailstostartorrunsforonlyafewseconds,callaqualiedservicetechnician.

3
RESTARTING BURNER AFTER EXTENDED SHUT DOWN.
Thecompleteoilburnershouldbecheckedandservicedbyaqualiedtechnician.
• Checkoilpumpstrainer
• Replaceoilltercartridge
• Checkelectrodes
• Oilburnermotor(seelubricationsection)
• Restartburnerbyfollowinginstructionsin;“STARTINGTHEOILBURNER”section.
• Ifyourfurnacehasbeenshutoffforanextendedperiod–contactyourqualiedservicetechnician
 forstart–up
SUMMER FAN OPERATION
Duringsummer,continuousaircirculationcanbeobtainedbypulling/slidingthemanualfanswitchfrom
the“Auto”positiontothe“On”position
DUAL AIR OPERATION
Thisfurnaceisequippedwithadual(two)speedblowersystemwhichallowspartialairdistribution
atalltimes.WhenthethermostatcallsforHeat,theOilBurnerstartsandtheHIGHspeedquickly
distributeswarmairthroughoutthehome.WhentheHIGHSPEEDstops,the“LOW”speedcontinues
operating,circulatingtheairtoeventhetemperaturethroughoutthehouse.Ifthe“LOW”speedfeature
isnotrequired/desired,operatethesmall“rocker”switchlocatedonthepowerjunctionbox.
MAINTENANCE
OIL FURNACE ANNUAL SERVICE
The oil burner and furnace should be thoroughly cleaned and serviced annually by a qualied service
technician, and where required by law, a licensed technician.
Thenozzleshouldbechangedannually-handlenozzlewithcaresothattheinsidesurfacetipisnot
scratched.Theelectrodesshouldbecleanedandadjusted(seeoilburnermanualwiththeoilburner).
LUBRICATION
Apply2–3dropsofSAE20–30NonDetergentoilONLYtotheoilport(s)locatedateitherendofthe
burnermotor.
Apply2–3dropsofSAE20–30NonDetergentoilONLYtotheoilportslocatedateitherendofthe
blowermotor.DO NOT OIL THE FAN BEARINGS!
CAUTION :
Beforecleaning,shutoffelectricalpowersupplytothefurnace.

4
CLEANING – OLM SERIES
Thisfurnaceshallbecleanedannually.Thisannualservicewillidentifyifdamagedorreplacementparts
arenecessary.
• Ifcleaningisrequired.Thefollowingstepsshouldbetaken.
• Disconnect(remove)uepipe.
• Removeuecollarpanellocatedattherearofthefurnace.
• Disconnecttheoillineandremovetheoilburnerfromthefurnace.
• Removebafefromsecondaryheatexchanger
• Cleanthesecondaryheatexchangerwithastiffbrushandvacuumcleanersuitableforthispurpose.
• Inspectheatexchangerpriortoreassembly
• Aftercleaningiscomplete,replacetheuebafe,collarplateandgasketswithNEW!
• Replacetheoilburner
• Atthebeginningoftheheatingseason,havethecompleteheatingsystemcheckedbyaqualied
 mechanic,andwhererequiredbylaw,alicensedmechanic.
NOTE:WERECOMMENDTHATAQUALIFIEDMECHANICORWHEREREQUIREDBYLAW,
A LICENCED MECHANIC ONLY SHOULD PERFORM ALL SERVICE AND CLEANING OF YOUR
SUMMERAIREFURNACE!
AIR FILTER
Thisfurnaceshouldneverbeoperatedwithoutlters.
A DIRTY AIR FILTER CAUSES INEFFICIENCY AND HIGHER OPERATING COSTS
Cleanorreplacelterseachheatingseason,orasrequired.
FilterspecicationsfortheairlterinstalledinyourSummeraireoilredwarmairfurnace,
arelistedbelow.
DONOTSUBSTITUTE!
Note: Changing the type or size of lter used in your Summeraire furnace can seriously affect the
operation of the furnace!
AIR FILTER SPECIFICATIONS
Filtersize:20”X20”X1”–CSAorULCCertied/Approved
Type:Throw-away/disposable
USE OF FILTERS OTHER THAN THOSE SPECIFIED ABOVE, CAN CAUSE DANGEROUS
ELEVATION OF FURNACE TEMPERATURES – THIS IS AN UNSAFE CONDITION !
DO NOT USE / INSTALL PLEATED TYPE AIR FILTERS IN THIS FURNACE !
WARNING:YourfurnacerequiresCombustionAir
DO NOTcloseofffurnaceroomorenclosefurnace-thiswillstarvetofurnaceoilburner 
 forairnecessaryforcombustionandcouldresultinadangeroussituation.
NOTE:
IFYOURSUMMERAIREFURNACEISINSTALLEDWITHASS2-CTJERNLUNDSIDEWALL
POWERVENTOR.
IT IS THE USERS / HOMEOWNERS RESPONSIBILITY TO KEEP THE AREA AROUND THE
VENT TERMINAL FREE OF ICE , SNOW AND DEBRIS !
F-OLM-USMAN-EN-REV2