SummerAire SE10B User manual

1
USER MANUAL
ELECTRIC
WARM AIR FURNACE
MODELS - SE10B (E) TO SE27B (E)
Save these instructions for reference
This furnace must be installed by a certied installer
and where required by law, a licenced technician.
FOR SERVICE CALL:
INSTALLATION INFORMATION
_________________ _________________
Installing Contractor Telephone Number
_________________ _________________
Unit Model Number Unit Serial Number
_________________
Date of Installation
MANUFACTURED BY
TRENT METALS LIMITED,
SUMMERAIRE MANUFACTURING

2
OPERATING SEQUENCE
HEATING
When the thermostat initiates the heating cycle the rst and second
sequencer turn on in sequence, the remaining sequencer relays are activated. The
on delay time is determined by the sequencer relay model. The blower starts at
heating at the same time as the rst element turns on. The indicator lights display
cycle activity.
COOLING
When the thermostat activates the air conditioning cycle. The blower starts at
high, cooling speed, and the A/C condenser is activated.
WARNING;FAILURE TO FOLLOW PROPER PROCEDURE MAY
RESULT IN SERIOUS HARM OR DEATH.
MANUAL CONTROLS
The POWER option and CONTINUOUS FAN switches are located on the fur-
nace upper panel.
When the POWER switch is set to “MAX”, all heating elements are operational.
When the POWER switch is set to “MODERATE”, the furnace operates at re-
duced heating capacity. This option, moderate power output option, is best suited
to spring and fall conditions or periods of low heat demands.

3
REMEMBER, during the winter months, this switch should be in the “ON”
position to insure maximum heating capacity.
The POWER switch must be set in the “MAX” position when a
2 – stage thermostat or outdoor thermostat is installed and used to control the
electric elements of the second stage.
The “CONTINUOUS FAN” switch turns the blower on to continuous “LOW”
speed. This feature will lter the air and provide for better distribution in the
building.
Manual Furnace Controls
CIRCUIT BREAKER
The circuit breaker is located at the right hand side of the front control panel
In the event of fan motor failure, the circuit breaker may trip.
Pushing in the white button will reset the breaker. If the button fails to remain
depressed, the fault condition may still exist.
Contact your service technician.

4
MAINTENANCE
PREVENTATIVE MAINTENANCE
Frequent servicing will avoid premature breakdowns. The heating system should
be inspected at least annually by a qualied service technician.
Do not attempt to repair the unit or its controls! Call a qualied service technician.
Before calling for repair service, check the following:
1. Check fuses or circuit breaker
2. Check if the 16 amp circuit breaker on the furnace has “tripped”
3. Set the thermostat higher than room temperature. If unit does not start, cut
power and call a qualied service technician.
MOTOR LUBRICATION
Do NOT lubricate the blower motor; it is permanently lubricated!
AIR FILTER
This furnace should never be operated without lters.
A DIRTY AIR FILTER CAUSES INEFFICIENCY AND HIGHER OPERATING
COSTS
Clean or replace lters each heating season !
Filter specications for the air lter installed in your Summeraire electric warm
air furnace, are listed below. DO NOT SUBSTITUTE !
RISK OF ELECTRIC SHOCK
TURN OFF all power before servicing unit.
If the power is NOT turned OFF, it can result in property
damage, bodily injury or loss of life
!WARNING

5
Filter size : 20 “ X 20 “ x 1 “ – CSA or ULC Certied /Approved
Type: Disposable
Note: Changing the type or size of lter used in your Summeraire furnace
can seriously affect the operation of the furnace!

6
WARRANTY
Summeraire Mfg., subject to the limitations described in this Warranty Certicate,
warrants each electric warm air furnace as follows.
1 ) All electric controls are warranted for a period of ve ( 5 ) years from date of
sale.
2 ) Elements are warranted for a period of 5 years from date of sale.
Model number; serial number and date of installation must be provided for all
warranty claims.
The foregoing Warranty applies only where the installation of the electric furnace
has been made in full accordance with all National and Local laws and ordinances
applying to the installation of electric warm air furnaces, and failure is not caused
by abuse, or failure to observe proper operating instructions supplied with this
furnace.
Warranty extends only to the repair or replacement of parts returned, freight
prepaid to our factory in Peterborough, Ontario, and which prove defective after
inspection and testing by Summeraire Mfg..
Any labour involved in effecting repair or replacement, including diagnostic
labour is excluded from this Warranty.
Warranty of parts replaced under this warranty ONLY assume the remaining
period of the Original Warranty.
LIMITATIONS
1) This warranty does not cover defects or damages on equipment without serial
number or where the serial number has been erased or modied.
2) This warranty does not apply to damage to the product caused by misuse,
failure to provide proper maintenance, accidents, Acts of God or inadequate
electric supply.
3) This warranty does not apply to air lters or any other materials which must
be replaced in the course of routine maintenance.
4) The operation of this furnace in the presence of corrosive elements such as
acids, chlorine, uorine, or other damaging chemicals voids this warranty.
5) Unauthorized alteration or repair of this appliance affecting product reliability
or performance voids this warranty.
6) This product must be installed by a competent, qualied installer in accor-

7
dance with Summeraire Installation Instructions, applicable local and
National Codes. Failure to do so voids this warranty.
7) This warranty applies ONLY to the original homeowner / purchaser.
8) This warranty does not include damages caused by improper matching or
application the product or product’s components.
9) This warranty is subject to the equipment being serviced and maintained, as
outlined in the Installation and User Manuals on an annual basis. Failure to
do so may void this warranty.
10) Summeraire Mfg. shall not be responsible for any consequential damages
caused by any defect in the product.
11) This is the ONLY warranty made by Summeraire Mfg. All other warranties,
conditions or guaranties, expressed or implied are hereby excluded.
Keep your warranty at work for you. Please complete and mail your warranty
Registration Card to Trent Metals Limited, 2040 Fisher Drive, Peterborough,
Ontario, Canada, K9J 6X6 to register this warranty.
F-SEB-USMAN-EN-REV2
Manufactured By
Trent Metals Limited,
Summeraire Manufacturing
Peterborough, Ontario,
Canada, K9J 6X6.