Summit SP5DS2DBLK User manual

0
Dual-Drawer Refrigerator
Réfrigérateur à deux tiroirs
User Manual | Guide d'utilisation
Models | Modèles :
SP5DS2DBLK (Black exterior | extérieur noir)
SP5DS2DSSHH (Stainless steel door | porte en acier inoxydable)

1
7. This appliance is designed for built-in use only into an enclosed
cabinet.
SAVE THESE INSTRUCTIONS
DANGER
Important Safeguards
When using this appliance, always exercise basic safety
precautions, including the following:
1. Read all of the instructions before using this appliance.
2. Use this appliance only for its intended purpose as described in this use and
care guide.
3. This refrigerator must be properly installed in accordance with the
installation instructions before it is used. See grounding instructions in
the installation section.
4. Never unplug your refrigerator by pulling on the power cord. Always
grasp the plug firmly and pull straight out from the outlet.
5. Unplug your refrigerator before cleaning or before making any repairs.
Note: If for any reason this product requires service, we strongly
recommend that a certified technician performs the service.
6. Repair or replace immediately, all electric power cords that have become
frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length, the plug or the connector end.
8. If your old refrigerator is not being used, we recommend that you
remove the door and leave the shelves in place. This will reduce
the
possibility of danger to children.
9. Do not operate your refrigerator in the presence of explosive fumes.
10. Cabinet edges along stamp/cut-out areas may be sharp. Please avoid
placing hands, fingers or other appendages near these areas.
11. This appliance is not intended for use by young children or infirm
persons without supervision. Young children should be supervised to
ensure they do not play with the appliance.
12. CAUTION: DO NOT USE EXTENSION CORDS.
Risk of child entrapment. Before you throw away your old appliance,
take off the doors. Leave the shelves in place so that children may
not easily climb inside.

2
Table of Contents
PAGE
Important Safeguards ............................................................................1
Parts and Overall Dimensions ..............................................................3
Pre-Installation Instructions .................................................................4
Preparation before installing ....................................................................4
Installation ................................................................................................5
Interior Parts ...........................................................................................6
Crisper .....................................................................................................6
Adjustable Divider ....................................................................................6
Drawers ...................................................................................................8
Upper Drawer ...........................................................................................8
Lower Drawer ...........................................................................................8
How To Use This Product .....................................................................8
Important notes before connecting the power supply ..............................8
Connect the power supply .......................................................................8
Interior LED bulbs ....................................................................................8
Temperature setting .................................................................................8
Centigrade and Fahrenheit Conversion ...................................................9
Power switch ............................................................................................9
Sabbath mode ..........................................................................................9
Door Ajar Alarm .........................................................................................10
Auto Defrost ...........................................................................................10
Cleaning ................................................................................................10
Troubleshooting ..................................................................................11
Limited Warranty ..................................................................................12
Thank you for using our Summit
product. This easy-to-use manual will
Model number:
guide you in getting the best use of
your refrigerator.
Serial number:
Remember to record the model and
serial number. They are on a label in
Date of purchase:
back of the refrigerator.
Staple your receipt to your manual.
You will need it to obtain
warranty service.

3
Parts And Overall Dimensions

4
Pre-Installation Instructions
This refrigerator is for built-in use only. Before use, this product must be
installed properly.
To allow for proper ventilation, leave a clearance of at least
3/16” on either side, 1/16” at the top and 2” at the rear when i
nstalling. Be sure
that airflow under the appliance is not blocked.
Note: Allow the unit to sit on its base for at least one hour before installation.
Preparation Before Installing
First, clean product's surface with a soft cloth. R
emove all protective
packaging covering the product.
1. Pull the upper drawer open. Refer to the illustrations below. Remove
crisper and set aside. Then place drawer dividers to one side as illustrated.
2. With two hands, lift up on the metal drawer divider rod to remove it from the
slots in the front and rear of the drawer. Once the drawer divider rod is free
from the slots (as illustrated), turn and lift so as not to hit the control panel.
3. Take the drawer divider assembly out of the upper compartment and place
safely aside.
Note: After completing these three steps, please close the upper drawer to
avoid damage to your person and product during installation.

5
Installation
1. Take off hinge cover(Part #1, page 3) with an upward motion. Refer to
illustration below:
2. Take the anti-tip bracket and screws from the accessory bag. Tighten
the anti-tip bracket on the top of the product with screws as follows in
the illustration.
Note: Follow instructions properly or you may do damage to the product.
so as not to damage accidently the cabinetryor
flooring. Then perform the
same adjustments to the front leveling legs to bring the front of unit to the
proper level to install the anti-tip bracket and fit evenly under the counter.
4.
Another set of anti-tip brackets for side installation is provided as option
when the counter top is granite and hard to fix by screws. This set of
brackets includes two anti-tip brackets and eight screws for installation on
left side and right side of the cabinet. The illustration below shows this. T
he
drawer needs to be open to perform this procedure.
necessary for a proper fit in the cabinet opening. Start with the rear legs
(if necessary) before you slide the unit fully into the opening - raise or lower the
rear legs to make the unit fit properly. Then carefully slide the unit into opening

6
Interior Parts
Crisper
One crisper with cover is located in the upper drawer.
Purpose:
Convenient storage of fresh vegetables. The user can remove the
crisper if it is not needed.
Adjustable Divider
There is an adjustable divider in each drawer. These can be adjusted for
flexibility in food storage. Dividers can be removed if not needed.
Note:If dividers are removed, keep them in a safe place away from
children. The drawers are designed to hold up to 44.1 lbs/20kg of food
items.
You can separate a compartment into various configurations, as shown.
The upper compartment is separated by a divider fastened to the bin cradle of the
upper compartment.
Those two dividers can be adjusted left and right, also back and
front. For left and right adjust: rotate directly. For back and front: you should press
the “PUSH” button (see illustration) in middle connector and move it back to front. If
you want to clean your refrigerator, you can remove the shelf foll
owing steps located
in section Preparation Before installation.

7
Purpose:
User can separate the upper compartment with divider according to
personal needs. This feature also keeps foods from falling down or spilling
when the drawers are opened or closed.
Adjust the divider in the lower compartment by referring to illustration:
The divider in the lower compartment is fixed between the embossments of
the
front and back walls of the drawer. You can choose different embossments to
divide into different spaces in the drawer.
Purpose:Separate the lower compartment with divider according to personal needs.

8
Drawers
Upper Drawer
Can hold any item under 12 inches tall.
Lower Drawer
Lower drawer is separated by a step. Foods or beverages whose height is less
than 12 inches can be kept in the space without the step. Smaller items can be
placed on the step.
How to use this product
Important Notes Before You Connect the Power Supply
Actual power supply should be kept in accordance with marks on rating
plate (115V/60HZ). Rating plate is on back of unit. Power socket should be
equipped with a 10A fuse. Allow the unit to sit on its base for at least one
hour before installation.
CAUTION: DO NOT USE AN EXTENSION CORD.
Connect the power supply
Unit is tested and set to operate at 38ºF before leaving the factory. When
connected with the power supply, unit will work properly.
Interior LED bulbs
An LED bulb is located on top of the interior liner in both the
upper and lower
compartments. It is controlled by the opening and closing of the drawer
: when
the drawer is open, the light is on; when drawer is closed, light is off.
Caution: There are magnets that are affixed to the left side of the interior upper
drawer and to the bottom of the lower drawer door. Don’t re
move them as they
are required for proper functioning of the light system.
Temperature setting
If you want to change the set temperature, press “SET” for three
seconds. The unit will beep, the temperature will flash on the control
panel, then you can adjust the figure using the ‘ ’ and buttons.
When the desired temperature appears on the display, press the “SET”
button again to confirm your setting. The user will hear a beep and the
temperature will no longer flash.
If you want to lower the temperature, press the ‘ ’ button. If you want
to raise the temperature, press the button.
Temperature range is : 34-45ºF (1-7ºC)
Control panel

9
Centigrade and Fahrenheit Conversion
Press and hold “SELECT” for 3 seconds. The
temperature display will change
from Fahrenheit to Centigrade and the unit will beep once. Press and hold
“SELECT” again for 3 seconds, and the display will change from Centigrade
back to Fahrenheit. Again, the unit will respond with a beep.
Power switch
The control panel has a P
ower button. If you want to stop unit from working
for a short time or to restart, press and hold “POWER”
for 3 seconds to turn
on and off.
Note:If you want to stop the unit from working for an extended period of
time, shut off the unit, unplug it, remove food, clean the refrigerator and
leave the drawers slightly open to prevent odors.
Sabbath mode
Press and hold ‘ and ‘ ’ at the same time for 3 seconds. The unit will beep
once and the display panel will flash 5 times and stop. This indicates that the unit
has entered Sabbath mode. In this mode, normal cooling operations still take place
(compressor, magnetic valve, fan, heater strip), but all luminous equipment
including display panel and LED bulbs will shut off, no matter if the door is open
ing
or closing.
To exit the Sabbath mode, press and hold and ‘ ’ at the same time for 3
seconds. The display panel will flash 5 times to indicate that the Sabbath model
has been disabled.
Note:This mode is available for the observance of certain religious holidays.