www.sunower-trimmer.com 8
• The machine is turned on by a backlit button on the front side.
• The lightless button works as the rotation reverse.
When holding the button the motor stops and the rotation changes.
• On the right side of the machine you can adjust the pressure of drifted cylinder.
More about rotor setup in chapter 3.3 Cylinder adjustment
• Electrical wiring and electrical components is described in section 2.3 Electrical wiring
• The machine can be used only for purposes specied by man-
ufacturer.
• We strongly advise you to read all safety warnings before use
of the trimmer!
• The machine is designed to separate the owers from the
stems of the plants.
• The machine can only be used on fresh plants with eshy
leaves and stalks which contains no ligneous and solid parts.
This means you can cut the plants whose composition and so-
lidity is similar to e.g. freshly harvested nettle.
The machine contains electrical parts and connections. Electrical connection means ca-
bles and other parts connecting the electrical devices. The electrical parts are: motor with
power consumption 370W, start up capacitor 20uF, 2 x power switch, potentiometr, 1x
euro connector, 1x frequency converter a 1x interference lter.
We particularly advise you to pay close attention to your safety during work and
maintenance of your trimmer. You should not get in contact with electrical connec-
tion when using or cleaning the machine. Do not alter or reconnect the electrical
connection!
2.1 GENERAL INFORMATION
The purpose of Bucker L device is to remove the owers from the stem.
The stem is inserted in the appropriate size orice from the front side of the device.
The stem is pulled in and the owers remain on the front plate of the device and drop into
the collection bin or on the conveyor.
2.2 RANGE OF USE
2.3 ELECTRICAL CONNECTION
