Sunlite 49148-SU User manual

INSTALLATION INSTRUCTIONS
1 of 2
Introduction
Installation
First refer to the size of the diagram to
drill holes in the wall.
Fix two screws to the hole
1 2 3
R 0.19”
2.75”
2.75”
R0 0.83”
14.48”
6.14”
Images are for illustrative purposes only. Actual fixture design is as illustrated above.
An internal power-factor-corrected switch-mode supply allows it to be used from any nominal 120V-277V, 60Hz AC supply
without any variation in light output.
Refer to the following diagram when you install the fixture. Two installation methods, directly fix to the mounting surface or fix
to the mounting surface with an arm.
49148-SU | LFX/RL/MW/SCT/PC
49149-SU | LFX/RL/HMW/SCT/PC
LED ROADWAY LIGHT |
Hook the lamp by two screws. Attach the
top screw. Finally tighten all screws.
Surface Mounting
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
WARNINGS: Avoid fire or electric shock. Follow installation instructions carefully.
If unsure about electrical installation, consult a qualified electrician. Wear
rubber-soled shoes and work on a sturdy wooden ladder. Ground fixture to avoid
potential electric shock. Handle metal parts carefully to prevent cuts. To avoid a
hazard to children, account for all parts and destroy all packing materials. Operat-
ing temperatures of -40°C to 45°C (-40°F to 113°F). Suitable for outdoor /wet
locations.
CAUTION: Turn off the power at fuse or circuit breaker box before installation and
maintenance to avoid electric shock. This product uses an input 120-277V AC
driver of wide range voltage, but the actual working voltage depends on the input
voltage of the photocell that is installed on the product. Normally the input
voltage of the photocell is 120V/208V/240V/277V Single range, and also has
120-277VAC wide range. please pay attention when installation.Fixture must be
installed according to national electric code and local building codes. If you are
unsure about wiring consult a qualified electrician.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Retain these instructions for future maintenance reference.

Note: Save these instructions for future reference.2 of 2
Installation completed.
Surface Mounting (Continued)
4 5 6
Arm Mounting
21 3
54 6
Pass the wire through the hole of the
cover plate. Connect the wire to the same
color (correspond to wire N, L and G)
together with a wire connector.
Put the cover plate into the U-slot, tight-
en the screws.
Assemble the two bent tube and tighten
them with nut and bolt.
Pass the power source wire through the
tube.
Connect the wires to the same color (
correspond to wire N, L and G) together
with a wire connector.
Put one end of the tube into the U-slot,
and then tighten the tube with two hex
socket screws. Please make sure that the
tube will not rotate.
Fix clamp on the pipe in a right position
and make sure that the pipe will not
rotate. Install the light fixture on the wall with
four screws through the clamp.