Sunlite t300 Installation instructions

7 DAY HEAVY-DUTY APPLIANCE TIMER
PROGRAMING & SAFETY INSTRUCTIONS
T300
05005-SU
WARNING
Applications:
Electrical shock hazard • Risk of injury or death • Risk of fire
• For indoor use only • Use a grounded outlet • Follow local electrical codes
Rated Voltage: 115VAC, 60Hz, 15A Max.Loading: 1725W
Timer Consumption Power: 2W Max.
• Lighting
• Heating systems
• Cooling systems
• Indoor sprinklers
• Humidifiers
• Nebulizers
• Aquariums
• Ventilators
RATINGS
Sunlite®• www.sunshinelighting.com
05005-SU-Timer Instructions02-flat.indd 105005-SU-Timer Instructions02-flat.indd 1 1/7/2011 12:26:22 PM1/7/2011 12:26:22 PM

BEFORE YOU START
SET UP DAY & TIME
PROGRAMMING / SCHEDULE
MODE SELECTION
○You may program the timer for up to 16 events per day.
○A time setting to Turn On, is an ON EVENT.
○A time setting to Turn Off, is an OFF EVENT.
• Press & Release PROG to enter PROGRAMING MODE and select your EVENT. (Fig 04)
Note: Every time you press PROG you advance to the next EVENT.
• Press WEEK to select your day/s for your selected EVENT. (Fig 05)
Note: Press WEEK multiple times until you get the day combination you want.
• Press HOUR then MIN to select a time for your selected EVENT. (Fig 05)
○Press Rto clear the display. Press Ragain to restore the display.
• Press & Hold CLOCK, and Press WEEK to select the current DAY. (Fig 02)
• Press & Hold CLOCK, and Press HOUR to select the current HOUR. (Fig 02)
• Press & Hold CLOCK, and Press MIN to select the current MIN. (Fig 02)
○DST - DAYLIGHT SAVING TIME
• Press HOUR & MIN simultaneously to activate or deactivate DST. (Fig 03)
Note: A small clock symbol will appear on the far right of the LCD screen, while DST is active.
○Plug timer in for at least 5 minutes before programing.
• Press RESET button (Using a pin), to reset the clock & timer.
○Note: These steps MUST be taken before initial use, or when
the timer needs to be reset.
○After setting up your timer, there are 4 operating modes:
• ON - Power is on - Timer is not active. (Fig 06)
• OFF - Power is off - Timer is not active. (Fig 07)
• AUTO - Uses the timer settings you programmed. (Fig 08)
• RANDOM - Adjusts your settings by random 2 minute increments of ± 30 minutes. (Fig 09)
This makes it look as if someone is in the house.
• Press ON/AUTO/OFF to select one of these modes. (Fig 06, 07, 08)
• Press WEEK & HOUR simultaneously to activate or deactivate the RANDOM mode. (Fig 09)
Note: A small hollow circle will appear on the far right side of the LCD screen, while RANDOM mode is active.
05005-SU-Timer Instructions02-flat.indd 205005-SU-Timer Instructions02-flat.indd 2 1/7/2011 12:26:48 PM1/7/2011 12:26:48 PM