
DESCRIPTION
Figure 1
Figure 2
PART # QUANTITY
ASolar Birdfeeder 1
B Rechargeable Batteries 1
CAUTION: Carefully separate the birdfeeder top from the lantern body. The LED stem is
enclosed and can be easily damaged when feeder top is removed.
Filling Solar Birdfeeder
1. (SEE FIGURE 1) Carefully lift the birdfeeder top and fill birdfeeder
to recommended fill level.
2. Close the birdfeeder top and hang in desired location.
Refilling Birdfeeder
NOTE: Refill birdfeeder when seed level is at or below refill level. Do not allow seed to
remain below recommended refill level.
1. (SEE FIGURE 1) Carefully lift the birdfeeder top and fill birdfeeder to recommended fill level.
2. Close the birdfeeder top and hang in desired location.
Care Instructions
NOTE: Do not use abrasives or chemicals to clean solar panels.
1. Remove any dirt and debris from the solar panels. Gently clean solar panels with a soft cloth.
2. Gently clean solar birdfeeder body with mild soap and water.
Rechargeable Battery Replacement
1. (SEE FIGURE 2) Carefully lift the solar lighted
birdfeeder top and open the battery
compartment underneath the top.
2. Remove the old batteries and replace the
them with new rechargeable batteries (B) of
the same rating.
3. Close the cover of the battery compartment
and replace the birdfeeder top.
4. Reference section "Operating Birdfeeder
Solar Light" to restore solar lighted
birdfeeder to full operation.
MAINTENANCE INSTRUCTIONS
A
B
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
Recycling
Please dispose of batteries properly.
Consult you local telephone listings
or a battery recycling center in your area.
2
1
PARTS LIST
CAUTION: Carefully separate the birdfeeder top from the lantern body. The LED stem
is enclosed and can be easily damaged when feeder top is removed.
Operating Birdfeeder Solar Light
NOTE: The rechargeable batteries are preinstalled from the factory. Before operating the
solar light, the rechargeable batteries inside battery compartment need to be fully charged.
1. (SEE FIGURE 1) Carefully lift the birdfeeder top and set the power switch to the "OFF" position.
Power switch is located under solar birdfeeder top.
2. Place the assembled solar birdfeeder in full sun, away from streetlights or other light sources
where it will receive direct sunlight for at least 8 hours per day. Other light sources may fool
the sensor and keep the light from coming on, or cause it to turn off automatically.
3. The batteries require at least 8-hours of full sunlight to charge. Once the batteries are fully
charged, set the power switch to the "ON" position.
4. The light will automatically turn on at dusk and off at dawn.
NOTE: The number of hours light is illuminated is directly proportional to the number of
hours of sunlight it receives. If the light is placed in a shaded area it will not fully charge
and reduce the hours of night time light.
Protect Ni-Cd batteries
against heat and fire
risk of explosion
Recycling
Do not dispose of
Ni-Cd batteries in
household waste
Do not throw
Ni-Cd batteries
into water!
Ambient temperature
maximal 40C (105F)
Recommended
Seed Level
Refill Level
Battery
Compartment
Cover
On/Off Switch
Battery