Sunrex EBK-317A User manual

mini Bluetooth Keyboard
Sunrex
(EBK-317A)
User Manual
Important Information
For Mac operating system, you can use the keyboard immediately.
Hardware Installation
1. Turn on the mini Bluetooth Keyboard:
• Bluetooth discovery starts and continues for 3 minutes.
The Status light blinks blue.
• If the Status light briefly turns red, charge the batteries. For more information,
see “Charge the batteries.”
2. Make sure your Bluetooth device feature is on. Select Settings > Bluetooth > On.
3. Select “mini Bluetooth Keyboard ” on the Bluetooth Devices menu.
4. If your device requests a PIN, enter the code using the mini Bluetooth Keyboard and
not your device's virtual keyboard. After the Bluetooth connection is made, the
Status light briefly turns blue, and then it turns off.
Note:
Charge the batteries:
1. Plug the Micro-USB Charging cable into the mini Bluetooth Keyboard and a USB
port on a computer. The Status light solid green.
2. Charge the batteries until the Status light turn off green.

Battery information:
• A fully charged battery provides about 3 months of power when the mini Bluetooth
Keyboard is used about two hours a day.
• Charge the batteries when the Status light briefly turns red after the mini Bluetooth
Keyboard turns on.
• When not in use, turn off the mini Bluetooth Keyboard to conserve battery power.
• The mini Bluetooth Keyboard enters sleep mode if powered on and not used. Press
any key to wake.
Use your product
Fn Off Fn On
~` Home
1 Lock screen
2 Slide-show
3 Search
4 Keyboard hide/show
5 Previous track
6 Play/Pause
7 Next track

8 Mute
9 Volume down
0 Volume up
delete Bluetooth connect button
Status light indications
Light Description
Green The battery is charging.
Blinking red Battery power is low . Charge the batteries.
Blinking blue Keyboard is in discovery mode.
Solid blue Bluetooth pairing is successful.
Rating:
Keyboard:3.7VDC 30mA
Max. operating temperature: 40∘C
CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Notice
Operation is subject to the following two conditions: (1) this device may
not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.