Sunsky ZF902 User manual

Thank you for choosing the single police law enforcement video and audio recorder -----ZF902, We hope
our products can support your work。
1. Introduction of product
Our company's single police law enforcement video and audio recorder contains night vision and video
and audio processing technology, full-featured and reliable performance.
Law - executor can timely record for collecting evidence and standardizing the law enforcement.
2. Product parameter
Specification
Display
2.0 inch 16：9 TFT LCD
Camera
angle
Built-in camera -130 degree angle of view
Memory
16GB Micro SD card for standard package. Up to 64GB
Picture
format
JPG, Maximum resolution:32 Mega pixels
Video
recorder
H.264, Resolution: 1920*1080, 1280*720 ,640*480
Infrared
night
vision
Infrared light, identify human face in 6 meters and see outline of human body
clearly in 15 meters.
Audio
Microphone and speaker built in
Battery
3.7V，3000mAh up to 10 hours video recording.
watermar
k
Device ID, Police ID and Date & Time.
Languag
e
Simple Chinese/English
PTT
Support
Water
proof
level
IP56
Work
temperat
ure
-20 to +70 degree Celsius
Storage
temperat
ure
-40 to +80 degree Celsius
3. Quick operating guide
Press to turn it on and enter idle mode;
Press to record video;
Press to take photo
Press to record audio

Press to enable Infrared light, this key can be used as up navigation key, fast-forward keyand
Zoom- in key too.
Press to turn on laser light，this key can used as down navigation key, rewind key and zoom-out key.
Short-press to playback last video or photo and for confirmation in menu setting window.
Press to go back last window.
Press to turn off/on screen, press and hold this key to enable torch.
Press to enter setting menu.
Press to restart device during device halted.
4. Device and key instructions

5. Screen instruction

6. Operation instructions
6.1 Power on
Press and hold 2 seconds to turn device on ，green indicator will be on and screen enter
pplayback status.
6.2 Video recording
Press to record video, vibrator and voice will alert you for starting recording video, video
recording icon will be flashing during recording video. Press again to stop recording and save
file.
6.3 One key to start video recording
Press and hold 3 seconds to start video recording during power off status.
6.4 Take picture
Under pplayback mode, press to take and save picture
6.5 Audio record

Under pplayback mode, press Vibrating one second and yellow led flashing, device start to
record audio. Press again to stop recording and save file.
6.6 One key to record audio
Power off status, press and hold 3 seconds to start recording audio directly.
6.7 Infrared night vision/Up navigation key
Under playback mode or video recording status, press to enable/disable infrared light. In the
menu press to select to up direction. Under playback mode，press to enter fast-forward
function
6.8 Laser light/Down navigation key
Under playback mode or recording video mode, press to enable/disable laser light.
Under menu mode or playback mode, press to select the next item. Press to execute
rewind function while playing a video.
6.9 Menu key
Under preview mode, press and input password according to prompt window，(Default
Password is continuously press six times) then you can setup device function and
parameters.
6.10 Back key
In menu setting mode, press to back last window;
Press and hold it to enable flashing and alarming mode.
6.11 `OK Key
Under preview mode, press to input password for review video and photos (Default
Password is continuously press six times) press or to choose other video and
pictures.
6.12 Torch/screen key
Under preview and recording video mode, press to turn on /off screen display;
Press and hold this key to turn on/off torch function.
6.13 Settings
Under preview mode, press and input password according to prompt window，(Default

Password is continuously press six times) then you can setup device function and
parameters.
Press or to choose item and press to confirm press back last menu.
A. Resolution of video：Three types for video recording：1080FHD 1920*1080,720P1280*720，VGA
640*480;
B. Resolution of picture：16M 5120*3200 12M 4032*3024 10M 3648*2736 8M 3264*2448 5M
2592*1944 3M 2048*1536 2M 1920*1080 1.3M 1280*960.
C. Image quality：Fine, standard, economy ，three modes.
D. Vehicle mode ：off mode,5 minutes,10 minutes,15minutes,once enable vehicle mode, video
recording will go to loop mode.
E. Motion detection：Once enable it, video record function will start automatically while one object is
moving in front of camera.
F. Screen auto off：OFF, 1minute, 3 minutes. Once you enable it ,it will enhance standby time.
G. Power auto off：OFF, 1minute, 3 minutes, 5mintues ,total 4 modes.
H. Key tone：OFF, Low, standard, high ,total 4 modes.
I. Police alarm：OFF, On, total two modes.
J．Infrared light：On, OFF.
K．Video record delay：OFF, 30seconds, 1 minute. Once you enable it, camera will record 30 secons
or 1 minute after you stop recording.
L．Audio record：On, off modes. It is optional for recording video.
M．Language：Simple Chinese，Traditional Chinese，English.
N．Date/Time：set up date and time for the device.
O. Connection password：Under preview mode, press and input password according to
prompt window，(Default
Password is continuously press six times) then you can setup device function and
parameters.
P．Police no.： enter this item and press or to choose item， press to confirm and
press to back last item.
Q. Default setting：Reset device to default setting.
R．Version：to check firmware version.
6.14 USB port
Connect computer for copy files and connect charger for charging the device.
6.15 HDMI Port
HDMI Port can be connected with HDTV or other display device for video display directly.
6.16. AV IN/OUT Port
Connect extra camera, the video and audio are all from extra camera

6.17 PTT—USB port
Connect PTT device and transfer voice.
6.18 LED indicator
Charging mode: Red led is on;
Power on mode: Green led is on;
Recording video: Red led is on;
Recording audio: Yellow led is on.
6.19 Reset key
Press and hold this key 2 seconds to restart device during device is halted.
6.20 PTT Key
Once connect this device with Walkie-talkie, it can be used for extra microphone of walkie-talkie.
Press this key to enable/disable start icon while recording video for differentiating important or normal
video file.
6.21 Charging battery
Lithium ion battery is used in this device.
It will take 5.5 hours around for fully charged the battery under power off status.
Red led will be on during charging status and Red led will be off after battery is fully charged.
6.22 Connection computer
When you connect device to computer, device will prompt you to input password(Default
Password is continuously press six times). Once password is matched, you can copy and
read files via computer.
User needs to know
Single police law enforcement, audio and video recorder products are our company honor products, by
our company responsible for after-sales service products. In order to better protect the interests of users
and avoid unnecessary problems, please read the following details in detail:
1. when you purchase it, please ask the sales unit to fill in [warranty card] of the relevant
content, and add to the sales unit seal.
2. For device fault [man-made damage such as water, moisture, and other damage caused by improper
use], unit maintenance without modification or authorization in the company when, and law
enforcement recorder products more than the warranty period, the company will provide paid service,
users need to pay a fixed fee.
3. serious human failure machine (such as liquid or broken machine, etc.), maintenance and
maintenance units signed [maintenance agreement] to decide whether to agree to pay maintenance.
4. for damp. Influent. Serious damage. Illegal modification of the law enforcement recorder, after
authorized maintenance institutions, do not rule out other new problems. The company is not
committed to fully repair, this is the fault caused by the ability to repair.
5. if only the host failure, and in accordance with the replacement condition, only the replacement of the
host part, other parts are not to be replaced.

Warranty card
Year month day
User information
User name
Mobile number
Unit name
Unit address
Device information
Device type
Device number
Sales(stamp)
Maintenance information
Repair
date
Repair
record
Repair unit
Repair date
Repair
record
Repair unit