Step 1:
Step 3:
Page 4 of 13
With a second person’s assistance, place the fire pit table top (A)
and fire pit table base (B) upside down, as shown.
Line up the bolt holes on the fire pit table top (A) with the
corresponding bolt holes on the fire pit table base (B).
Screw the M6*22 bolts (AA) with flat washers (BB)
using the wrench (CC). Tighten all the bolts as shown.
Spread the decorative glass (F) out evenly over the burner area.
Use all the glass provided for best effect. Keep the glass
clear of igniter spark to avoid accidental blockage.
A percentage of glass beads may arrive split in half.
This is normal. Additional beads may split after use.
DO NOT BURN WITHOUT GLASS
BEADS OR OTHER SUBSTRATE
SUCH AS LAVA ROCK IN BURNER.
ASSEMBLE ON A FLAT SOFT
SURFACE SO YOU DON’T SCRATCH
OR DAMAGE THE TABLE TOP.
Step 2:
F
BB
AA
CC
A
B
OFF
ON
DD
Before operating the fire pit, consumer will need to install the AAA Batter
the OFF position. To install the battery open the plastic battery compartment as shown in step 2, and insert the battery
making sure you insert it with the correct polarity as shown in the diagram.
holder by twisting clockwise and closing the battery compartment.
If the unit is not in operation for a long time, remove the battery until you are ready to use product day to day.
Never dispose battery directly into trash and keep away from fire.
Please recycle battery to protect the enviroment.
