Superior G1SP2001 User manual

Model # G1SP2001
ASSEMBLY INSTRUCTIONS
12 in 1 GAMES TABLE

Corner Pocket Caps Side Pocket Caps

Basketball
Return Net

Attach the Side Pockets (#66) to the table using four Screws (#67)
per Pocket,and the Corner Pockets (#65) using two Screws (#68).
Attach one Leg Base (#13) to the bottom
of each leg (#4) using two screws (#14)
per Leg Base.
Next ,screw one Leg Leveler (#33) into
the top of each Leg Base.

Attach the Previously-assembled Legs (#4) to the end of the Billiard
Attach the Corner Pocket Caps (#21) and the Side Pocket Caps
(#22) using two Screws (#69) per cap.
Cabinet (#7) using one Bolt (#18) and two Bolts (#17) per leg use
the Alley Key (#74) provided.

Attach the Basketball Rim (#58) to the Backboard (#5) using four
Bolts (#62) and four Nuts (#63).
Install the Rod Caps (#31) on the top of the Upper Basketball Short
Pole (#55) on the back of the Backboard.
Attach two Upper Basketball Short Pole (#55) to the Backboard using
four Bolts (#19) and four Nuts (#20).
Next, attach the Upper Basketball Short Pole (#55) to the Lower
Basketball Crooked Pole (#54) using four Screws (#61).

Attach the Basketball Net (#57) to the Rim (#58) by slipping the top
of the wet over the Rim hooks.
Attach the Basketball Return Net (#56) to the Upper Basketball Short
Pole (#55) using Rivet Plug (#53).
55

Attach Side Panel (#1) and End Panel (#2) using Screws (#16).
Slide the Playfield (#3) with the graphic facing down, into the grooves
of the Side Panel (#1) and End Panel (#2) assembly.

Place the Field Support Brace (#6) on the Playfield (#3) and attach
using three Screws (#16) per Brace.
Slide the Player Rods (#71-73) through the bushing of one Side Apron.
Place one Rod Bumper (#30), then two Rod Washer (#29) and then
another Rod Bumper (#30) on the Rod at the middle of the table.
Next, insert the rod through the bushings in the other Side Apron
(at the other side of the table).
Attach Side Panel (#1) and End Panel (#2) using Screws (#16).
3

Insert one Player Rivet (#70) into a Player Front (#23 or #26).
Place the Player on a Player Rod (#71,#72 or #73) so the Player Rivet
Passes through the hole on the Player Rod.
Place the Player Back (#24 or #27) on the Player Rod making sure that the
Player Rivet inserts into the Back.
As you hold the Player Front and Back together on the rod. Screw a Player
Head(#25 or #28) onto the Player.
Place the Rod Handle (#32) onto each Player Rod and Rod Cap (#31).
Attach the Slide Scorer (#12) using to the top rail two Screws (#15)
per scorer.