Suptek SPM201XL User manual

SPM201XL
INSTALLATION MANUAL Supplied parts list
Tools Required
Before you start
·Phillips Screwdriver ·carpenter’s level
·3.8MM drill bit ·8MM masonry bit
Mounting the wall bracket to the wall
Optional Speaker Wire
Management Step 1
This pack contains 2 speaker mounts
Suitable for loads up to 30kg（66lbs）each speaker
UNPACKING INSTRUCTIONS
Carefully open the carton, remove contents and lay out on cardboard
or other protective surface to avoid damage.
Check package contents against the Supplied Parts List in the next
page to assure that all components were received undamaged. Do
not use damaged or defective parts.
Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
Install and operate this device with care. Please read this instruction
before beginning the installation, and carefully follow all instructions
contained herein. Use proper safely equipment during installation.
Please call a qualified installation contractor for help if you:
If you don’t understand these directions or have any doubts about the
safely of the installation.
If you are uncertain about the nature of your wall, consult a qualified
installation contractor.
Do not use this product for any purpose or in any configuration not
explicitly specified in this instruction. We hereby disclaims any and all
liability for injury or damage arising from incorrect assembly, incorrect
mounting, or incorrect use of this product.
(2)Wall
Bracket-a
(2)Wall Bracket
Cover-b
(2)Tilting End Cap-c (2)Speaker
Platform-d
(2)M8x60mm
Bolt-e
(2)Plastic Washer-f (2)M8 Washer-g (2)M8 Nut-h
(10)M4x12mm
Wood Screw-i
(8) M6x45mm
Lag Bolt-j
(1)wrench-m
(8)Lag Bolt
Washer-k
(8)M8x40mm
Concrete Anchor-l
Option A : Wires are concealed inside the wall
Option B : Wires are exposed outside the wall
Note: The mounting components and hardware supplied in this
package are not designed for installations to walls with steel
studs or to cinder block walls. If the hardware you need for
installation is not included, please consult your local hardware
store for proper mounting hardware for the application.

Attaching the wall bracket cover and the
speaker platform to wall bracket
OPTIONAL:secure speaker using
M4x12 wood screws
Step 2
Step 4 Adjusting the tilting angle and swing
the speaker
Step 5
Placing speaker on the platform,adjust
clamps to hold speaker in place
Step 3
Thank you for choosing our products!
[email protected]