Svedholm Unit User manual

SVEDHOLM DESIGN AB
Unit
2021-06-09

A flexible modular shelf in
perforated powder coated steel.
Shelf H460 × W230 × D240 mm
Bookend W180 × H100 mm
Design by
Malin Berglund
and Anna Sjöberg
Unit

5
On the following pages of this brochure you will find a few installation suggestions and instructions on how to assemble these.
21 3
4 6
How to assemble your Unit shelf
This is how
the assembly
template looks like.
Unit consists of two dier-
ent kinds of shelves, right
shelves and le shelves.
RIGHT
R
LEFT
L
• Start by checking that you have the assembly template, the back plates and the shelves.
• You need the following tools to assemble the Unit shelf:
drill / screwdriver and screws suitable for your wall type.
• Lay out the assembly template on the floor and plan how you want to assemble your shelf.
Mark where the back plates should be placed on the template with a pencil. NOTE that the
assembly template and the back plates should have the arrow pointing upwards.
• Attach the template on the wall with the arrows facing upwards and make sure it is levelled.
• Pre-drill the wall according to the template where the back plates will sit.
• Remove the assembly template from the wall.
• Screw the back plates with the arrows facing upwards on the wall.
• Start assembling your shelf from the bottom upwards by hooking the four metal pulleys,
which are attached on the back of the shelf, into the back plate. NOTE that each shelf can be
rotated in four dierent positions.
• Assemble bookends if desired.

Tripp trapp
R
3×
L
3×
Assembly instructions
Here you need
Lay out the assembly template on the
floor and mark where the back plates
should be placed on the template
with a pencil. NOTE that the assembly
template and the back plates should
have the arrow pointing upwards.
Attach the template on the wall with
the arrows facing upwards and
make sure it is levelled.
Pre-drill the wall according to the tem-
plate where the back plates will sit.
Remove the assembly template from
the wall.
Screw the back plates with the
arrows facing upwards on the wall.
Start assembling your shelf from the
bottom upwards by hooking the four
metal pulleys, which are attached on
the back of the shelf, into the back
plate. NOTE that each shelf can be ro-
tated in four dierent positions.
Assemble bookends if desired.
3 pcs le shelves
3 pcs right shelves
L
RL
RL
R

R
RL
L
Fyrklöver
R
2×
L
2×
Assembly instructions
Here you need
Lay out the assembly template on the
floor and mark where the back plates
should be placed on the template
with a pencil. NOTE that the assembly
template and the back plates should
have the arrow pointing upwards.
Attach the template on the wall with
the arrows facing upwards and
make sure it is levelled.
Pre-drill the wall according to the tem-
plate where the back plates will sit.
Remove the assembly template from
the wall.
Screw the back plates with the
arrows facing upwards on the wall.
Start assembling your shelf from the
bottom upwards by hooking the four
metal pulleys, which are attached on
the back of the shelf, into the back
plate. NOTE that each shelf can be ro-
tated in four dierent positions.
Assemble bookends if desired.
2 pcs le shelves
2 pcs right shelves