
Windsor Multi Play Set (MPS132B)
Thank you for purchasing the Windsor Mul Play Set (MPS132B)
Warning: Only for domesc outdoor use.
This Play Set sasfies all the requirements of the Australian Standard AS/NZS ISO 8124 and has been cerfied by an indepen-
dent laboratory. To guarantee safety, please give special aenon to the assembly, safety, and care instrucons detailed in
this document.
ASSEMBLY ADVICE
- Follow the instrucons exactly.
- This product must be assembled by adults.
- Once assembly has been completed, keep the instrucons in a safe place for future reference. This can be parcularly handy
for idenficaon of parts if any aer sales service is required.
- Before commencing assembly, check that none of the parts are missing. If you find that you are missing a part please contact
our aer sales service department.
- Retain extra parts to use as spares in the future if necessary.
- Pre-Drill mber before fixing with screws to avoid cracks in the mber.
The dimensions given in the instrucons are indicave only, they may vary according to the assembly method.
SAFETY ADVICE
- As per legal requirements, a swing seat with flexible means of suspension must have a 40cm minimal distance between the
ground and the swing. This distance is important for safety. The distance between the swing seat and the ground and the
trapeze and the ground can be adjusted using the plasc height adjustment hooks.
- Warning: This product is only to be used by children between the ages of 3 and 12.
- Warning: Not to be used by anyone weighing over 50kgs, simultaneously not to exceed a combined weight of 100 kgs.
- Warning: Choking hazard - small parts can be dangerous for children.
- Warning: This play set must be used under adult supervision.
- This product is for private use at home only. Under no circumstances is it to be used in parks, schools, camp sites, hotels,
public leisure areas etc.
- The swing set should be set up on a flat surface at least 2 metres away from any structures or obstacles (walls, fences, trees,
washing lines, cables etc).
- To avoid eye damage, we advise that the swing and slide should not be setup directly facing the sun.
- The swing set should be installed over impact absorbing surfaces such as sand, wood-bark chips, rubber and foam and must
NOT be set up on a hard surface (concrete, tarmac etc). For detail on surfacing materials please refer to the aached consum-
er informaon sheet.
- Please see below diagram for maximum fall height of swing.
- The anchorage must be checked regularly.
- Dispose of packaging thoughully.
- Do not allow children to play with packaging.
- Maximum fall height for swing set please refer below graphic.
CAUTION ! This Product includes mber and/or fabric, Please Keep away from fire.
FIXING INTO THE GROUND
IMPORTANT ! For safety reasons, your Play Set must be embedded into the ground.
- Place your Play Set in the desired posion and mark a square area 250mm x 250 mm around each of the feet. Dig holes 300 mm
deep. (The feet must be in the center of the square)
- Fill the holes with concrete. Do not exceed the ground level. Fit the embedding piece into the center of the concrete so that fixtures
for screwing the posts into place rise out of the concrete.
- When the concrete is dry, screw the posts to the embedding pieces.
- Anchors shall be placed level with or under ground in order to reduce tripping hazards.
IMPORTANT ! Wait unl the concrete is set before using and check anchorages regularly.
MAINTENANCE
- All parts should be checked at least once a month.
- Check all nuts and bolts for ghtness and ghten when required.
- Check for signs of wear to bolt coverings. If sharp edges are found, replace as required.
- In certain regions (seaside areas), certain coangs could be prone to damage. In this case, it is advised
to use a rust prevenon treatment.
- Check swing seats, chains, ropes and other means of aachment for evidence of deterioraon; replace when required in accordance
with the manufacturer's instrucons.
- All parts that are under constant fricon should be oiled regularly using a suitable lubricant.
- The ground on which the play centre is set up should be cleared regularly. All objects such as stones or anything else that could cause
injury in the case of a fall should be removed.
- It is recommended that during the winter period when the equipment is not in use, all apparatus are removed to prevent deteriora-
on due to bad weather.
- Sand rusted areas and tubular members and repaint using a non-lead based paint when required
- Modificaons to the original acvity toy should only be carried out under instrucons from the manufacturer.
- Defecve parts should only be replaced in accordance with the manufacturer's instrucons.
- For aesthec reasons, you may want to apply a mber treatment to the mber parts.
All outdoor wooden products require roune inspecon and regular maintenance. Aer installaon, a follow-up inspecon should
take place aer one week and twice a month thereaer for the remaining life of your play products. Maintenance should be
performed at any me it is deemed necessary. As a general rule, major maintenance (wood refinishing) should be performed at
twelve month intervals from the date of installaon. Inspect and perform maintenance based on the following checklist.
Major wooden parts: Inspect for splintering and structure defects at regular intervals. For very minor splinters or chipping, lightly
sanding and refinish with an exterior water repellent stain can assist. If mber has cracked or split significantly, replacement parts may
be required, please contact naonal customer service centre for any replacement requirements.
At regular intervals, the applicaon of a penetrang oil based sealer stain to all wooden components is essenal. Please consult your
local hardware or home improvement store for recommendaon of an appropriate product. Ensure the product does not contain
hazardous chemicals once dry that can pose a potenal health risk to children.
We hope you have a safe and enjoyable me using the Windsor Mul Play Set (MPS132B).
Customer Support: (03) 9786 0055