Swing Slide Climb Windsor Multi Play Set User manual

Windsor Multi Play Set (MPS132B)
Thank you for purchasing the Windsor Mul Play Set (MPS132B)
Warning: Only for domesc outdoor use.
This Play Set sasfies all the requirements of the Australian Standard AS/NZS ISO 8124 and has been cerfied by an
independent laboratory. To guarantee safety, please give special aenon to the assembly, safety, and care instruc-
ons detailed in this document.
ASSEMBLY ADVICE
- Follow the instrucons exactly.
- This product must be assembled by adults.
- Once assembly has been completed, keep the instrucons in a safe place for future reference. This can be parcular-
ly handy for idenficaon of parts if any aer sales service is required.
- Before commencing assembly, check that none of the parts are missing. If you find that you are missing a part please
contact our aer sales service department.
- Retain extra parts to use as spares in the future if necessary.
- Pre-Drill mber before fixing with screws to avoid cracks in the mber.
The dimensions given in the instrucons are indicave only, they may vary according to the assembly method.
SAFETY ADVICE
- As per legal requirements, a swing seat with flexible means of suspension must have a 40cm minimal distance
between the ground and the swing. This distance is important for safety. The distance between the swing seat and
the ground and the trapeze and the ground can be adjusted using the plasc height adjustment hooks.
- Warning: This product is only to be used by children between the ages of 3 and 12.
- Warning: Not to be used by anyone weighing over 50kgs, simultaneously not to exceed a combined weight of 100
kgs.
- Warning: Choking hazard - small parts can be dangerous for children.
- Warning: This play set must be used under adult supervision.
- This product is for private use at home only. Under no circumstances is it to be used in parks, schools, camp sites,
hotels, public leisure areas etc.
- The swing set should be set up on a flat surface at least 2 metres away from any structures or obstacles (walls,
fences, trees, washing lines, cables etc).
- To avoid eye damage, we advise that the swing and slide should not be setup directly facing the sun.
- The swing set should be installed over impact absorbing surfaces such as sand, wood-bark chips, rubber and foam
and must NOT be set up on a hard surface (concrete, tarmac etc). For detail on surfacing materials please refer to the
aached consumer informaon sheet.
- Please see below diagram for maximum fall height of swing.
- The anchorage must be checked regularly.
- Dispose of packaging thoughully.
- Do not allow children to play with packaging.
- Maximum fall height for swing set please refer below graphic.
CAUTION ! This Product includes mber and/or fabric, Please Keep away from fire.
FIXING INTO THE GROUND
IMPORTANT ! For safety reasons, your Play Set must be embedded into the ground.
- Place your Play Set in the desired posion and mark a square area 250mm x 250 mm around each of the feet. Dig holes 300 mm
deep. (The feet must be in the center of the square)
- Fill the holes with concrete. Do not exceed the ground level. Fit the embedding piece into the center of the concrete
so that fixtures for screwing the posts into place rise out of the concrete.
- When the concrete is dry, screw the posts to the embedding pieces.
- Anchors shall be placed level with or under ground in order to reduce tripping hazards.
IMPORTANT ! Wait unl the concrete is set before using and check anchorages regularly.
MAINTENANCE
- All parts should be checked at least once a month.
- Check all nuts and bolts for ghtness and ghten when required.
- Check for signs of wear to bolt coverings. If sharp edges are found, replace as required.
- In certain regions (seaside areas), certain coangs could be prone to damage. In this case, it is advised
to use a rust prevenon treatment.
- Check swing seats, chains, ropes and other means of aachment for evidence of deterioraon; replace when
required in accordance with the manufacturer's instrucons.
- All parts that are under constant fricon should be oiled regularly using a suitable lubricant.
- The ground on which the play centre is set up should be cleared regularly. All objects such as stones or anything else
that could cause injury in the case of a fall should be removed.
- It is recommended that during the winter period when the equipment is not in use, all apparatus are removed to
prevent deterioraon due to bad weather.
- Sand rusted areas and tubular members and repaint using a non-lead based paint when required
- Modificaons to the original acvity toy should only be carried out under instrucons from the manufacturer.
- Defecve parts should only be replaced in accordance with the manufacturer's instrucons.
- For aesthec reasons, you may want to apply a mber treatment to the mber parts.
IMPORTANT NOTICE FOR TIMBER CARE & MAINTENANCE
This product contains mber components that are naturally subject to deterioraon in the outdoor elements. All
outdoor mber products require roune inspecon and regular maintenance.
To combat the effects of outdoor exposure and greatly increase the lifespan of your play set or cubby,we strongly
recommend that you apply a protecve coat of exterior grade lacquer or oil to all mber parts upon first assembly.
In order to best maintain the mber we recommend reapplying protecve coats every 3 months.
Failure to care for your mber parts by applying protecve lacquer or oil will greatly reduce the lifespan of your
product.
For informaon on the most suitable exterior lacquer or oil, please consult your hardware specialist. Please ensure
the product does not contain hazardous chemicals once dry that can pose a potenal health risk to children.
To ensure connued safety of your product, Major mber maintenance should be performed at twelve month
intervals from the date of installaon. All mber parts should be inspected for splintering and structural defects and
treated as follows:
- For very minor splinters or chipping, a light sand and coat of exterior water repellent oil/varnish is suitable.
- If mber has cracked, roed, or split significantly, replacement parts may be required. Please contact our customer
service team on [phone] for all replacement part enquiries.
We hope you have a safe and enjoyable me using the Windsor Mul Play Set (MPS132B)
Customer Support: [phone]

31
4 5 6
2

7
10 11
8 9

12
14 15
13

19 20
16
18
17

24 25
232221

28
29 30
26 27

32
31

3433
35