Front Panel Controls and Jacks
Ring Modulator
The ring mod circuit only uses the three bottom left jacks; none of the other jacks or controls
apply to it.
● Patch two audio signals into IN 1 and IN 2.
● Patch the output into a mixer; the two signals should combine together. Some frequency
combinations will sound better than others, so mess around with it a bit!
Wave Folder
LVL
● The LVL pot increases the amplitude of the affected waveform or the waveform to be
folded until it folds. Along with the TAPS switch, it controls the number of folds in the
waveform. This pot will not function unless the MIX pot is above 0%.
OFST
● The OFST pot controls the offset. This pot will not function unless both the MIX and LVL
pots are above 0%. It can’t be used to offset the dry signal alone.
● The OFST pot can adjust the folded wave up or down to help achieve the desired timbre
and wave symmetry and can make folded waves clip. Adjust to taste.
● The example below shows a symmetrically folded wave. Notice how the smaller folds
coming from top and bottom are the same size. These folds don’t have to meet in the
middle for them to be symmetrical, so long as they are the same size.
● Here’s an example of an asymmetrical wave: one big wave-hump on one side.
5