User Manual 14 User Manual 15
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
This device complies the part 15 of the FCC Rules. Operation is subject to the following two conditions:
1)This device may not cause harmful interference and 2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However. there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions accepted by the FCC with the product transmitting at its highest certified
power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of
the product while operating can be well below the maximum value. Before a new model is a available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, tests foreach product are performed
in positions and locations as required by the FCC.
For body worn operation, this device has been tested and meets the FCC RF exposure when used with an accessory designated for this
product or when used with an accessory that Contains no metal.
To maintain compliance with the FCC RF exposure guideline, hold the transmitter and antenna at least 2.5 centimeters from your face
and speak in a normal voice, With the antenna pointed up and away from the face
In accordance with EU Directives and Regulations
Quanshun Communication Technology Co., Ltd
ADD: Quanshun Bldg., Daxiamei, Nan'an, Quanzhou, Fujian, China 362302
as the manufacturer, hereby declares under our sole responsibility that
product(s): Two Way Radio
Model name: D30 is in conformity with the essential requirements of the Radio Equipment Directive 2014/53/EU:
Radio EN 303 405 V1.1.1 (2017-05)
Article 3.2
EMC EN 301 489-1 V2.2.3 (2019-11)
Article 3.1(b) EN 301 489-5 V2.2.1 (2019-04)
The notified body Bay Area Compliance Labs Corp.(BACL) (EU Identification Number: 1313) performed
a conformity assessment according to Annex III, Module B.
Signed on behalf of Quanshun Communication Technology Co., Ltd
(Signature of authorized person)
Name: Roger Chen
Title: Manager
Tel: +86-595-86753355 Fax: +86-595-86758299
Safety EN 62368-1: 2014 + A11: 2017
Article 3.1(a)
Health EN 50566:2017
Article 3.1(a)
