Baofeng BF-82 User manual

6

Indicator

~
HIGHT:UHF:4W/VHF:5W
LOW:UHF/VHF:1W

This device complies wit h part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Any
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Warning:
Safety training Information
Your radio generates RF electromagnetic energy during transmit mode. This radio is designed
This radio has been tested and complies with the FCC RF exposure limits for " occupational
1. FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance with FCC Guidelin
2. American National Standards Institute ( C95.1-1992 ), IEEE Standard for Safety Levels with
3. American National Standards Institute ( C95.3-1992 ), IEEE Recommended Practice for the
and classified as "occupational Use Only" meaning it must be used only during the course of
employment by individuals aware of the hazards, and the ways to minimize such hazards. This
radio is NOT intended for use by the " eneral population "in an uncontrolled environment.
Only" In addition, your FUJIAN NAN'AN BAOFENG ELECTRONICS CO.,LTD. radio complies
with the following Standards and Guidelines with regard to RF energy and electromagnetic
energy levels and evaluation of such levels for exposure to humans:
-es for Human Exposure to Radio Frequency Electromagnetic Fields.
Measurement of Potentially Hazardous Electromagnetic Fields- RF and Microwave.
Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.

4. The following accessories are authorized for use with this product. Use of accessories other
To ensure that your expose to RF electromagnetic energy is within the FCC allowable limits for
occupational use, always adhere to the following guidelines:
1. DO NOT operate the radio without a proper antenna attached, as this may damaged the
2. DO NOT transmits for more than 50% of total radio use time (“50% duty cycle”). Transmit
3. ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body when transmitting
and only use the BAOFENG belt-clip which is listed in instructions when attaching the radio
than those ( listed in the instruction ) specified may result in RF exposure levels exceed the
FCC requirements for wireless RF exposure.
radio and may also cause you to exceed FCC RF exposure limits. A proper antenna is the
antenna supplied with this radio by the manufacturer or antenna specifically authorized by
the manufacturer for use with this radio.
-ting more than 50% of the time can cause FCC RF exposure compliance requirements to
be exceeded. The radio is transmitting when the “TX indicator” lights red. You can cause
the radio to transmit by pressing the “PTT” switch.
to your belt, etc., to ensure FCC RF exposure compliance requirements are not exceeded.
To provide the recipients of your transmission the best sound quality, hold the antenna at
least 5 cm ( 2 inches ) from your mouth, and slightly off to one side. The information
listed above provides the user with the information needed to make him or her aware of RF
exposure, and what to do to as*sure that this radio operates with the FCC RF exposure
limits of this radio.
Electromagnetic Interference / Compatibility During transmissions, your BAOFENG radio
generates RF energy that can possibly cause interference with other devices or systems. To
avoid such interference, turn off the radio in areas where signs are posted to do so. DO NOT
operate the transmitter in areas that are sensitive to electromagnetic radiation such as
hospitals, aircraft, and blasting sites. Occupational/Controlled Use .
The radio transmitter is used in situations in which persons are exposed as consequence of
their employment provided those persons are fully aware of the potential for exposure and
can exercise control over their exposure.