Tandberg Data BizNAS D400 Series User manual

BizNAS™ D400 series
Registration Code
www.tandbergdata.com
Installing Disks
Technical Support
Follow these instructions to install one or more disks
into your NAS.
Open the cover door. Slide the disk tray lock to the right to
release the handle.
Pull the tray out by the handle.
Slide the disk into the disk tray.
Flip the tray over and use the three supplied screws to secure
the disk into the tray.
Visit the Support section of the Tandberg Data web site
(http://www.tandbergdata.com) for the following:
• Knowledge base articles
• Troubleshooting information
• Product documentation
• Software updates
• Product warranty and registration
• Email and phone technical support
Insert the disk tray into the empty slot.
Close the handle to secure the disk tray into the slot.
©2012 Tandberg Data. All rights reserved. BizNAS is a trademark of Tandberg
Data. All other trademarks are the property of their respective owners. #1020489A#
1.
2.
3.
4.
5.
6.

12
3 4
If your NAS shipped without disks, refer
to the back of this Quick Start Guide
to install one or more disks before you
setup your NAS.
5
Ensure that you have:
• A local area network that is up and running.
• An available Ethernet port on your LAN switch or router.
• Access to the Internet from a computer connected to the LAN.
Note: The BizNAS D400 series retrieves its IP address and
other network addressing automatically via DHCP. After you
have accessed the Tandberg Data BizNAS Information Center,
you can change to static network addressing, if desired.
START HERE
Turn Power OnConnect Network and Power Cables
Discover your NAS Launch the Information Center Congure your NAS
• Connect the supplied Ethernet cable to an Ethernet port on
the NAS. Connect the other end of the cable to an Ethernet
port on a switch or router.
• Connect the supplied power cable that is appropriate
for your region to the NAS. Plug the power cord into an
electrical outlet.
• From a computer on the same network as the NAS, type
http://ndmynas.tandbergdata.com in a web browser.
The NAS Discovery page opens.
Click the NAS IP address link in Step 3 of the NAS Discovery page to
launch the Tandberg Data BizNAS Information Center.
Tips for a Successful Setup
Click Get Started from the BizNAS Information Center Home
page to begin the NAS setup process.
Basic NAS setup involves three main steps:
1. Conguring disks.
2. Creating storage volumes.
3. Creating shared folders.
• Type your NAS registration code, which is located on
the front cover of this Quick Start Guide.
• Click Submit.
Note: You can add volumes and shared folders during disk conguration.