
Troubleshooting: TAXA Mantis
Plumbing
a. open gray water valve to drain
Remove kitchen shelving unit to access plumbing (secured with
three bolts). Squeeze or remove trap to loosen clog.
Inspect sink drain, p-trap, and drain hose, tighten where
necessary
Loose connection,
sand / grit in quick
disconnect
Flush out exterior quick disconnect with water to remove grit
Loose
connection(s) or
bad washer
Tighten connection between shower wand and hose; between
hose and faucet; remove faucet and replace rubber washer.
remove access panel below shower, visually inspect and tighten
connections.
Plumbing leaks behind
kitchen cabinetry
Pressurize system, observe leak spot. Tighten hose clamps and
or PEX fittings.
Plumbing leaks under trailer
Check plumbing connections in problem area and tighten if loose
loose connection
or over pressured
water.
Check push pull connectors at heater (push and pull them to
check if one is loose!) at heater. Remove and re-insert. Ensure
city water is below 125PSI and is being regulated by pressure
regulator at inlet.
Drawing air in
water supply line
Tighten line by checking connections back to water tank from
sink; tighten or re-connect. Check connection also beneath trailer.
Sometimes you can hear air entering line when water pump is
turned on.
Vent blocked up
or crimped
Blow out vent line (small hole just above fill area)
If crimped, remove bend in line. (accessible by removing service
panel beneath Vberth)
Check fuse
beneath water
pump switch at
kitchen.