TBI PRO Engineering Indoor Bug Zapper User manual

QUICK START GUIDE
HOW TO REPLACE THE LIGHT TUBES HOW TO CHANGE ATTRACTANT
STEP 4
Rotate gently the tubes until you see
the golden tube plug from the tube
socket gap. When you see the golden
tube plug connector in the tube socket
gap, then you have scrolled everything
correctly. After that, carefully remove
the lamp from the connector.
ATTENTION: When replacing the
lamp tube, you should hold the
lamp head part. Do not grab the
transparent glass tube to avoid
leaving fingerprints, sweat and
dirt, which will affect the ultraviolet
transmission effect.
STEP 5
STEP 6
Insert the replacement tubes with
new extra free 2 tubes. Insert
the replacement tubes with gold
connectors into the tube socket gap,
and gently scroll clockwise.
Close the protective grid. Press on it so
that it closes.
Insert the electrical plug to an outlet
and turn on the bug zapper to check
the light of the tubes.
STEP 1
STEP 2
Unplug the
power cord.
Remove the
Bug Tray.
STEP 3
STEP 4
Remove the attractant cartridge from the
sealed pouch and remove the protective cover
from the face of the cartridge.
Avoid touching the openings in the
cartridge and always wash your hands
thoroughly after contact.
Place the attractant at the spot marked in
bug tray on the picture.
Wash hands thoroughly after
handling.
Back the Bug tray in the Bug Zapper bottom.
Сhange the
attractant
every 30 days!

If you will have any questions, feel free to contact us
by phone number:
[phone] (Free)
or via email:
suppor[email protected]
Suggested suspension height:
keep the product hanged at a height of 4 ft (1.2 m) at a distance of
1 ft (0.3m) from the wall.
The device can be mounted on the ceiling using a hanging chain.
For installation, drill holes with a 9 mm drill. Depth 80-90 mm.,
Insert into the dowel holes.
Into dowel are screwed hooks, on which an insecticidal lamp is
subsequently suspended using a chain.
SAFETY NOTICES INSTALLING HOW TO REPLACE THE LIGHT TUBES
Plug in with dry
hands only
Not allowed for use by
children under 16
Change the attractant only
when the device is turned off
Wash hands with soap after
changin the attractant
Do not leave
unattended
Forbidden for
children to play
STEP 1
STEP 2
Unplug the power cord.
ENSURE screwdriver and
hands are Dry! Discharge the
internal electrified grid by using a
screwdriver with plastic handle:
Insert the metal tip of
the screwdriver onto the
internal electrified grid.
You may hear and see a
zap.
insert the metal tip of
the screwdriver onto the
internal electrified grid
until there are no zaps.
STEP 3
Flip the device 180 degrees to
the back of the device. Press the
black protective grid down to
the bottom. The protective grid
is spring-loaded, then lower it
down.