TBK vision TBK-6321SDO User manual

Hi-Speed Dome Camera
Outdoor Housing
Instruction Manual
OUTDOOR HOUSING

Rev 1.2
2
Warning & Caution
General Features
NamesofEachPart
A. Basic Parts
B. Accessories
Installation
A.WallMountBracket
B. Pipe Mount Bracket
C. Gooseneck Mount Bracket
D. Corner Mount Adaptor
E. Pole Mount Adaptor
Fan / Heater
Specification
CONTENTS
3
3
4
4
5
6
6
7
8
9
9
10
11

Rev 1.2
3
If you fail to read this information and
handle the product incorrectly, death or
serious injury may occur.
1. Outdoor Housing
2. Wall Mount Bracket
Screw (M4x16 screw 5EA)
4. Manual
5. Cable ties ( 5 EA)
6. Wrench ( 1 EA)
7. Screws (M3 x 6) 2EA
8. Screws (M3.5 x 22) 2EA
The unit should be installed by trained
Never install the product in area exposed
water, oil or gas.
Never install the product on a ceiling that
cannot hold its weight.
Never touch the power cord with wet hands.
What’s in the Box?
IP 66
Outdoor Housing acquires weatherproof capacity
IP66.
Various cameras
Accepts many manufacturers’ unitized camera
systems.
Various Mount Brackets
Available in Wall, Pipe, Gooseneck Mount
Brackets and Corner mount adaptor, Pole mount
adaptor
Built-in Fan / Heater
Luxury and Classic design
Input power: With Camera - 24V AC
18 watts at 24V AC
Heater: 18watts
Fan: 2watts
The heater activates at +10℃(±5℃),
deactivates at +15℃(±5℃)
The fan activates at +45℃(±5℃),
Deactivates at +35℃(±5℃)
General Features
Warning & Caution

Rev 1.2
4
A. Basic Parts
1. Wall Mount Bracket
2. Sun-visor
3. Housing
4. Bubble
5. Ceiling Mount Bracket for indoor camera
6. Fan
7. Heater
8. Circuit Board
9. Pipe Mount Bracket
Name of each Part
1
2
4
3
5
6
7
8
FIG.1
9

Rev 1.2
5
B. Additional Accesorries
Name of each Part
TB-105 – Pipe mount bracket TB-106 – Goose neck mount bracket
TB-107 – Corner mount adaptor TB-109 – Pole mount adaptor

Rev 1.2
6
A. Wall Mount Bracket
<the cable into the ceiling> <the cable out of the ceiling>
A-1. To install Wall Mount Bracket
Tip Select a ceiling board strong enough to hold 4 times the total weight of the camera
(weight combined camera : approx.5kg)
A-2. Screw up the Bracket tightly using the wrench (M4.0) after putting the rising into the hole.
A-3. Screw up the bubble tightly to prevent water.
Installation
FIG.2
FIG.3 FIG.4

Rev 1.2
7
B. Pipe Mount Bracket
<the cable into ceiling> <the cable out of ceiling>
B-1. Wind the Seal Tape around the tap of pipe and screw down the Housing.
B-2. Put Silicon Sealant into the connection part.
<thecableintotheceiling> <thecableoutoftheceiling>
B-3. Rotate the pipe and fix to the ceiling bracket.
SILICON SEALANT
THREAD SEAL TAPE
FIG.5
FIG.6
Installation

Rev 1.2
8
C. Gooseneck Mount Bracket
C-1. Wind the Seal Tape around the tap of pipe and screw down the Housing.
C-2. Put Silicon Sealant into the connection part.
<the cable into the ceiling> <the cable out of the ceiling>
C-3. Rotate the pipe and fix to the ceiling bracket.
THREAD SEAL TAPE
FIG.7
SILICON SEALANT
FIG.8
Installation

Rev 1.2
9
D. Corner Mount Adaptor
D-1. Install a corner mount adaptor on the corner of wall.
D-2. Install fixable brackets (wall, gooseneck) with a corner mount adaptor
E. Pole Mount Adaptor
E-1. Install a pole mount adaptor on the pole.
Installation

Rev 1.2
10
E-2. Install fixable brackets (wall, gooseneck) with a pole mount adaptor
Joint with adaptor or
Dome camera power
HEATER
FAN
AC24V 1A
FIG.7
Fan / Heater
FIG 11

Rev 1.2
11
MODEL Outdoor Housing
Temperature for Heater working On: below 10, Off: over 15
Temperature for Fan working On: over 45, Off: below 35
Temperature Range of Use -40℃~ +60
Humidity Range of Use Below 90%
Waterproof Capacity IP 66
Construction Poly Carbonate (Glass), Aluminum (Body)
Dimensions 253Ø(diameter) x 307mm(Height) x 190Ø(Bubble)
Power Consumption 18W Max (With Camera: 38W Max)
Power Supply AC 24V 1A, 60 / 50Hz (AC24V 2A with camera)
Weight 3.4kg (With Camera 5.3kg)
Specification
97.0
253.0
190.0
210.0
UNITS:mm
580.0

Rev 1.2
12