TD Electronics TDE-SIREN-EX User manual

User Manual of Explosion Proof Fire Alarm Siren TDE-SIREN-EX
Version: 20210314001AS
TDElectronics
Model No.: TDE-SIREN-EX
Address: Av. Colón 6818. Talcahuano- Chile
Tel No.: [phone]/ [phone]
Email: [email protected]
www.tesladelta.cl
Thank you for using our products. Pls read this manual before operation.
Overview
TDE-SIREN-EX explosion-proof alarm siren is a conventional type
fire alarm device, ideal for hazardous environment fire system
notification.
TDE-SIREN-EX explosion-proof alarm siren can be used with manual
alarm call point to make up of a simple and independent fire alarm
combination equipment.
TDE-SIREN-EX explosion-proof alarm siren can be used with fire
alarm control panel, in case of fire, the control panel receives alarm
signal from fire detector or call point, then the panel sends an
activation signal to the alarm siren.
TDE-SIREN-EX explosion-proof alarm siren has high sound level up
to 110dB@1m. It has reasonable structure, reliable performance,
high reliability and strong anti-interference ability.
TDE-SIREN-EX explosion-proof alarm siren complies with
GB3836-2010 standards for explosion proof performance. The
explosion-proof siren is applicable to Zone 1 and zone 2, containing
the hazardous area ofⅡC T6 temperature explosive gas atmosphere.
Parameters
 Explosion-proof mark: Ex dⅡC T6 Gb
 The ambient temperature: -10° C ~ +55° C
 Relative humidity: ≤95% (non-condensing)
 Atmospheric pressure: 80~110KPa
 Ingress protection grade: IP65
 Working voltage: DC24V
 Alarm current: ≤600mA

User Manual of Explosion Proof Fire Alarm Siren TDE-SIREN-EX
Version: 20210314001AS
TDElectronics
 Sound intensity: 100~110dB
 Cable inlet: G1/2”
 Sound type: fire sound
 Gross weight: about 1.6kg
Appearance and Dimension
F 向旋 转
should be removed, and use an at least S
≥
8 mm
2
cross-sectional
area rubber cable to connect it , otherwise, the detector will lose its
explosion-proof performance.
Installation: Use M6 bolts to fix the siren through its mounting rack
to the wall or ceiling.
Connection: Loosen the fixing screws of the siren bottom cover, open
the wiring chamber, connect the cables to the wiring terminals (see
the figure below). After connecting the wires, install the cover and
main body.
D D
D and D is for DC24V power terminal
Figure 2
Figure 1
Operation
Testing: The end user should test the device after unpacking the
shipping carton. Testing guidance is as follows:
Connect DC24V wires to the power terminals in the siren and power
in on, it’s qualified if the device give an audible alarm.
When the siren is connected to fire alarm system, the testing wires
Precaution
1. It is strictly forbidden to disassemble the electrified device in
inflammable and explosive places.
2. Keep the explosion proof base clean and dry, be careful not to
damage it during installation. The fastening screws of the
explosion-proof base should be tightened. Be careful not to mix
foreign objects on the explosion-proof base.
3. If the device is in long-term use, please maintain it regularly, make
sure the device is in good condition and with good performance.
Please give to professionals for repair if the device has any failure or
damage.
1 4 0
φ 1 30
5 0