Teak Isle Holy Night Outdoor Nativity Set User manual

ALL DESIGNS ARE COPYRIGHTED PROPERTY OF TEAK ISLE MFG., INC.
Star Assembly (1)
Holy Night Outdoor Nativity Set - Standard Size
Assembly Instructions
Manger - Left (1) Manger - Right (1)
Holy Family (1)
Fences (2)
Sheep (2)
Ground Stakes (2)
Illustrations are colored for clarity
1
Interlock manger components
together at roof.
Front View
2
Rear View
Center plate
rests on top
of manger
assembly
Fit star assembly over
assembled manger
components.
Optional (Included)
3
8" Diameter x 40"
Reinforcement Rods (2)
(See additional instruction sheet)
Stake Reinforcement
Clips (4)
Stainless Steel Screws (8)

3
7
5
4
ALL DESIGNS ARE COPYRIGHTED PROPERTY OF TEAK ISLE MFG., INC.
Lock side fences into manger assembly.
Either fence can be used on either side
of unit. Lock the Holy family into the side fences.
Rear View
Fences will angle inward towards rear of set
after the Holy Family is assembled.
Leg extensions drive into ground.
Locate sheep as desired.
6
Drive stakes
into the
ground over
corner
connector as
shown to
secure unit.
For accessories and product questions,
visit us at www.outdoornativitysets.com
Your Nativity set is
now complete.
Enjoy!

ALL DESIGNS ARE COPYRIGHTED PROPERTY OF TEAK ISLE MFG., INC.
Holy Night Outdoor Nativity Set - Standard Size
Optional Support Fastening Instructions
Locate holes on rear of left and right Manger
components - 2 pairs of holes per side.
(Left side shown here)
1
2
3
Secure plastic stake retainers with screws provided.
IMPORTANT:
Use care not to over tighten screws.
Insert reinforcement rods through retainers and
drive into the ground as required.

Donkey
Shepherd
and Sheep
Angels
Illustrations are colored for clarity
Calf
Assembly Instructions
for separately sold Nativity Figures
Locate holes on back of
each figure
1
2
3
Secure stake retainers with
screws provided.
IMPORTANT:
Use care not to over tighten screws.
Wise Men
Camel
Hardware
Reinforcement
Stakes:
Stake Retainers (16) (or 2 per figure)
Stainless Steel Screws (32) (or 4 per figure)
Insert reinforcement stakes
through retainers and drive into
the ground as required.
Each figure has mounting holes for
support hardware. Angel is shown
here for example.
(3) @ 20" for:
(5) @ 28" for:
Camel, Donkey, Calf
Wise Men, Angels, & Shepherd
ALL DESIGNS ARE COPYRIGHTED PROPERTY OF TEAK ISLE MFG., INC.
For accessories and product questions,
visit us at www.outdoornativitysets.com