SNUGSQUARE IDO PEDESTAL User manual

IDO PEDESTAL

Gather Your Eggs...
Full Base Accent Base Contour Base
Table Top
Note: Please retain all boxes until you are certain that your product isn’t damaged and that you
do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
12x Pins

Align pins with the holes along the edge
of the Accent Base.
Tap pins into holes, leaving just under
half an inch exposed.
Place the pieces on a soft
material so they won’t scratch.
Step 1: Insert Pins Into the Accent Base
Insert pins into the edges of the Full Base
and the Contour Base.
Do not insert pins into the “face” sides.

Step 3: Attach to Full Base
Align the pins on the edge
of the Accent Base with the
holes on the “Face-Side” of
the Contour Base.
Once aligned, push the
pieces until the edges are
flush. Do not hammer as it
may damage edges.
Step 2: Attach Accent Base to Contour Base
Align the pins on the edge of the Contour
Base with the holes on the “Face- Side” of
the Full Base.
Once aligned, push the pieces until the
edges are flush. Make sure to keep the
Contour Base perpendicular to the Full
Base while pushing.
Do not hammer as it may damage
edges.

Step 4: Attach Table Top
Step 5: Flip Table Upright
With the Table Top facing down,
align the base pins with the holes
on the Table Top.
Gently push the pieces into the
holes one side at a time.
Flip table over and press down on
the Table Top.
Pat over all the pin areas until
Table Top is flush.

Now your Ido Pedestal
is ready for use.
DONE!