Techlogix TL-TP70-HDIR-LT User manual

User Manual
TL-TP70-HDIR-LT
70m HDBaseT Extender Set for HDMI & IR
All Rights Reserved
Version: TL-TP70-HDIR-LT_160923

TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
Preface
Read this user manual carefully before using this product. Pictures shown in this
manual are for reference only; the actual product may vary.
This manual is only for operation instruction only and not for any maintenance or
repair.
Trademarks
Product model and logo are trademarked. Any other trademarks mentioned in this
manual are acknowledged as the properties of the trademark owner. No part of this
publication may be copied or reproduced without prior written consent.
FCC Statement
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. It has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in
a commercial installation.
Operation of this equipment in a residential area is likely to cause interference, in
which case the user at their own expense will be required to take whatever
measures may be necessary to correct the interference.
Any changes or modifications not expressly approved by the manufacture would
void the user’s authority to operate the equipment.

TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
SAFETY PRECAUTIONS
To insure proper operation, please read all instructions carefully before using the
device. Save this manual for further reference.
l Unpack the equipment carefully and save the original box and packing material
for possible future shipment
l Follow basic safety precautions to reduce the risk of fire, electrical shock and
injury to persons.
l Do not dismantle the housing or modify the module. It may result in electrical
shock or burn.
l Using supplies or parts not meeting the products’ specifications may cause
damage, deterioration or malfunction.
l Refer all servicing to qualified service personnel.
l To prevent fire or shock hazard, do not expose the unit to rain, moisture or install
this product near water.
l Do not remove the housing of the device, as opening or removing housing may
expose you to dangerous voltage or other hazards.
l Install the device in a place with adequate ventilation to avoid damage caused by
overheating.
l Keep the device away from liquids.
l Spillage into the housing may result in fire, electrical shock, or equipment
damage. If an object or liquid falls or spills on to the housing, unplug the device
immediately.
l Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power
to the device before cleaning.
l Unplug the power cord when left unused for a long period of time.
l If disposing of the unit, do not burn or mix with general household waste. The
device must be disposed of per local regulations for electronic recycling.

TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
Contents
1. Introduction ........................................................................................................... 1!
1.1 Introduction to HDBaseT Extender Set ........................................................ 1!
1.2 Features ........................................................................................................ 1!
1.3 Package List .................................................................................................. 1!
2. Panel Description ................................................................................................... 2!
2.1 Transmitter ................................................................................................... 2!
2.2 4K HDMI Receiver ........................................................................................ 3!
3. System Connection ................................................................................................ 4!
3.1 Usage Precautions ........................................................................................ 4!
3.2 System Diagram ............................................................................................ 4!
3.3 Connection Procedure .................................................................................. 4!
3.4 Twisted Pair Cable Connection ..................................................................... 5!
4. Specification .......................................................................................................... 6!
4.1 Supported Resolution ................................................................................... 7!
5. Panel Drawing ........................................................................................................ 8!
6. Troubleshooting & Maintenance ............................................................................ 9!
7. After-sales Service ............................................................................................... 10!

1
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
1. Introduction
1.1 Introduction to HDBaseT Extender Set
The extender set consists of a transmitter and receiver pair. HDMI signals are input
into the transmitter and HDBaseT technology is used to transmit the signals to the
receiver up to 70 m via a Cat5e/Cat6 cable. The receiver then outputs the HDMI
signal.
Bi-directional IR is also transmitted across the Cat5e/Cat6 cable. The extender set
supports PoC, which can be used to power the receiver via the Cat5e/Cat6 cable.
This eliminates the need for power at the receiver end.
1.2 Features
• 1080p, 3D, 4K@30 compatible
• 70m max distance for 1080p
• 40m max distance for 4K@30
• Single twisted pair transmission (shielded recommended)
• HDMI 1.4 / HDCP 1.4
• Bi-directional IR
• Diagnostic LEDs
• Single power supply required – powered at the transmitter
• CEC transmission supported
• HDBaseT
Note: Shielded twisted pair cable with shielded connectors are recommended.
1.3 Package List
Ø 1 x Transmitter
Ø 1 x Receiver
Ø 4 x detachable mounting ears
Ø 4 x screws
Ø 8 x plastic cushions
Ø 1 x power adapter (DC 12V 1A)
Ø 1 x user manual

2
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
2. Panel Description
2.1 Transmitter
1) HDMI IN: Connect to HDMI source.
2) IR IN: Connect to an IR receiver. Signals from this port are transmitted to the
receiver.
3) IR OUT: Connect to an IR emitter. Signals from this port are transmitted from
the receiver.
4) Power Indicator: illuminates when properly powered.
5) DC 12V: Connect the included power supply. This port powers both the
transmitter and receiver.
6) TP OUT: Connect to the TP IN socket on the receiver via a twisted pair cable.

3
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
2.2 4K HDMI Receiver
1) HDMI OUT: Connect to HDMI display.
2) IR IN: Connect to an IR receiver. Signals from this port are transmitted to the
transmitter.
3) IR OUT: Connect to an IR emitter. Signals from this port are transmitted from
the transmitter.
4) Power Indicator: illuminates when properly powered.
5) TP IN: Connect to the TP OUT socket on the transmitter via a twisted pair
cable.
Note: the extender set features two indicators on the RJ45 port that show real-time
operation information:
Indicator
Function
Details
Green
(HDCP)
Show input signal
connection
When Connected:
HDCP Compliant: Illuminate
Not HDCP Compliant: Blink
When Disconnected: No signal
Yellow
(LINK)
Indicates linking status
of the transmitter and
receiver
When Connected: Illuminate
When Disconnected: No signal

4
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
3. System Connection
3.1 Usage Precautions
1) System should be installed in a clean environment that has a proper temperature
and humidity.
2) All of the power switches, plugs, sockets and power cords should be installed
properly.
3) All devices should be connected before powering on the devices.
4) The twisted pair terminations for the devices should be a straight-thru
conforming to the TIA/EIA T568B standard.
3.2 System Diagram
3.3 Connection Procedure
Step1. Connect an HDMI source (such as a set top box) to the HDMI IN port of the
transmitter with an HDMI cable.
Step2. Connect TP OUT port of the transmitter to TP IN port of the receiver using a
twisted pair cable.
Step3. Connect an HDMI display to HDMI OUT port of the receiver with an HDMI
cable.
Step4. If IR control is required, perform the following:
a) Connect the IR emitter to the IR OUT port on either the transmitter or
receiver.
b) Connect the IR receiver to the IR IN port on either the transmitter or
receiver.
Step5. Connect the DC 12V power adaptor to the power port of the transmitter.
The receiver is powered via the twisted pair connection and does not require
a separate power supply.
HDTV
DVD
IR Remote
CAT5e/CAT6
4K HDMI Transmitter
4K HDMI Receiver

5
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
3.4 Twisted Pair Cable Connection
The Cat5e/Cat6 terminations for HDBaseT devices should be a straight thru
connection conforming to the TIA/EIAT568B standard. The TIA/EIA T568A
standard is NOT recommended.
Note: For best operation, the twisted pair cable should be shielded and the cable
connectors should be metallic. The shielded layer of cable MUST be connected to
the connector’s metal shell.
TIA/EIA T568A
TIA/EIA T568B
Pin
Cable color
Pin
Cable color
1
green white
1
orange white
2
green
2
orange
3
orange white
3
green white
4
blue
4
blue
5
blue white
5
blue white
6
orange
6
green
7
brown white
7
brown white
8
brown
8
brown
1st
Ground
4--5
1st
Ground
4--5
2nd
Ground
3--6
2nd
Ground
1--2
3rd
Group
1--2
3rd
Group
3--6
4th
Group
7--8
4th
Group
7--8

6
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
4. Specification
Transmitter
Receiver
Input
Input Signals
1 HDMI, 1 IR
1 IR, 1 RJ45
Input Connectors
HDMI female
3.5 mm mini jack
RJ45
3.5mm mini jack
Output
Output Signals
1 HDMI, 1 IR
1 IR, 1 RJ45
Output Connectors
HDMI female
3.5 mm mini jack
RJ45
3.5mm mini jack
General
Video Compliance
HDMI 1.4, HDCP 1.4, HDCP 2.2
Supported Audio
Up to 7.1 surround (8 channel)
Resolution Range
800x600@60Hz~4K@30
Transmission Distance
1080p: 220 ft. (70m)
4K@30: 130 ft. (40m)
SNR
>70dB@ 100MHz-100M
Bandwidth
10.2Gbps
THD
<0.005%@1KHz
Impedance
75Ω
Temperature
0 ~ 50°C
Reference Humidity
10% ~ 90%
Power Supply
DC 12V, 1A
Power Consumption
9.6W
Dimension (W*H*D)
61.6 x 24.3x 120.6 mm
Weight
0.28Kg
Included Accessories
Power Supply, IR Emitter, IR Receiver, Mounting
Brackets with Screws

7
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
4.1 Supported Resolutions
Format
Resolution
HDMI
480I, 480P, 576I, 576P, 720P, 1080I, 1080P, 4Kx2K, 1080P 3D
DVI
640x480@60Hz, 640x480@72Hz, 640x480@75Hz, 800x600@60Hz,
800x600@72Hz, 800x600@75Hz, 1024x768@60Hz,
1024x768@70Hz, 1024x768@75Hz, 1280x720@60 Hz,
1280x1024@60Hz, 1280x1024@75Hz, 1600x1200@60Hz,
1920x1080@60Hz, 1920x1200@60Hz

8
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
5. Panel Drawing
Transmitter
Receiver

9
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
6. Troubleshooting & Maintenance
l No image on display:
l Ensure that the display device has been set to the correct input.
l Ensure that the HDMI cables used for both the source/transmitter and the
receiver/display are properly connected and are working. Test the HDMI
cables directly from a source to display and ensure their operation.
l Ensure that the twisted pair cable has not been damaged and that it has been
terminated correctly with T568B on both ends. A temporary length of
twisted pair cable can be used for testing to ensure that the devices are all
compatible and working properly.
l Ensure proper grounding of the power supply.
l Known issues with HDMI 1.2 source devices:
Older compatibility (HDMI 1.2) may result in HDBaseT transmission issues.
Please contact Technical Support for a solution to these issues.
l Color lose or poor picture quality:
l Ensure that the HDMI cables used for both the source and transmitter and
the receiver and display are properly connected and are of good quality. Test
the HDMI cables directly from a source to display and ensure their picture
quality.
l Ensure proper grounding of the power supply.
l If the static becomes stronger or picture quality becomes worse when
connecting the video connectors, this may be due to improper grounding.
l Check the grounding and make sure all the components are properly
grounded to a common ground. Improper grounding may cause damage to
the receiver.
If your problem persists after following the above troubleshooting steps, please
contact your authorized reseller or TechLogix technical support.

10
TL-TP70-HDIR-LT User Manual
www.tlnetworx.com
7. After-sales Service
1) Product Limited Warranty: We warrant that our products will be free from
defects in materials and workmanship for three years.
2) Warranty coverage may be voided when:
l The warranty period has expired
l The factory applied serial number has been altered or removed from the
product
l There is damage, deterioration or malfunction caused by:
l Atypical wear and tear
l Use of supplies or parts not meeting the specifications
l No certificate or invoice as the proof of warranty
l Damage caused by force majeure
l Non-authorized service
3) Technical Support: When contacting TechLogix support, please have the
following information available:
l Product part number
l Installation and sale date
l Detailed failure information