tekkiwear SH-7196 User manual

Rechargeable Hair Clipper – SH-7196
User Manual
Before using the product, please read carefully the operang instrucons and keep properly for
future reference.
1. Only USB standart charger can be used with this product.
2. Charge voltage 5V(USB).
3. The temperature for the product's charge and storage should be between 5 and 35 ºC
4. Make sure the charge will not become damp (Fig 1).
5. Do unplug the charger before cleaning the shaver with running water (Fig 2).
6. Knife head can be washed without washing the body.
7. This product cannot be used by physically distempered, sensorially or mentally disordered, or
inexperienced persons (including children), unless they are under supervision or instrucon by
people in charge of their security.
8. Take care of children to keep them away from this product.
9. When the shaver is charging, the indicator lamp will be o. Press the switch buon back to
the o state for charge.

10. It's necessary to ensure to put the protecve cover on the shaver when you travel to protect
the shaver head.
11. Please clean inside beard if the shaver can not work aer you press the switch.
Charge
Make sure the product is power-o before the charge. The charge lasts about 3hours. It's beer
for the product not to be connected to the power supply for more than 24 hours._ ( Remark:The
indicator light will not change or turn o when it is fully charged.)
1. Insert the product charger into the shaver (Fig 3).
2. Plug in the charger .
3. The charge indicator lights up (Fig 4).
4. Aer the full charge, unplug the charger and also pull o the product's plug from the shaver.
How to Use Product
Shaving
1. Press the buon ON/OFF to start the shaver.
2. Make the shaver head part move quickly on the skin in straight lines and circles (Fig 5).
3. The shaver can run for ten days aer a full charge.
Cleaning & Maintenance
To ensure a beer shaving eect, the shaver must be cleaned regularly. The easiest and most
sanitary way to clean the product is to wash the shaver head part and the whisker storeroom
with water each me aer using it. Do be careful while using hot water. Do remember to check
the water is not too hot to avoid harming hands.

Every day: the shaver head part and the hair storeroom.
1. Cut o the power supply of the shaver, then unplug the charger and also pull out the product's
plug from the shaver.
2. Open the shaver head part (Fig 7).
3. Clean the shaver head part and the hair storeroom with hot running wáter (Fig 8).
Make sure both of the shaver head part and the hair storeroom be cleaned thoroughly.
4. Wash the products surface (Fig 9 ).
5. Close the shaver head part and throw o surplus water. Do not wipe the shaver head part
with a towel or paper ssues, which may cause damages to the shaver head.
6. Open the shaver head part again and remain so to dry up the product (Fig 10).
You can also use the brush included to clean the hair storeroom. Here water should not be used.
Store
It is recommended to dry the electric shaver rst, and put on a protecve cover to prevent
damage to the blade net and to avoid dust accumulaon in it Replace the cuer head In order
to get the best shaving eect it is recommended to replace the knife head and knife net every 6
months, please use original accessories.

Note: Only separate the hand-held part from the power cord before cleaning the hand-held part
in water.
Deep cleaning:
1. In the opened head cover, turn the xing frame release buon counterclockwise to take out
the xing frame
2. Remove the knife net (Fig11)
3. Separate the knife net and clean the knife net with a cleaning brush. (Fig12)
4. Aer cleaning, insert the knife net and the xing frame into the head cover in reverse order.
(Fig 13)
Maintenance
1. It is recommended to clean the knife net every two months.
2. Regular cleaning of the electric shaver can guarantee a beer shaving eect.
Note: Do not use a towel or paper towel to wipe the electric shaver knife net, because this may
damage the knife net.
Environmental Protecon
1. To discard the product, please don't put it together with general domesc rubbish heaps but
hand it to the ocially designated recycle center for the environmental protecon (Fig 14).

2. The built-in rechargeable baery contains substances which may pollute the environment, so
it must be unloaded from the product or sent to the ocially designated recycle center to be
disposed before it is discarded.
The baery should not be unloaded unless it has been used up.
1. Unplug the charger and also pull out the product's plug from the shaver.
2. Unload the baery. Do not plug in the shaver again aer unloading the baery.
3. We recommend going to a specialized technical service when you need to replace the baery.