Tekky Convulsing Werewolf User manual

CONVULSING werewolf
INSTALLATION AND OPERATING INSTRUCTIONS
KEEP ALL PLASTIC AND WIRE PARTS AWAY FROM CHILDREN
PARTS
1. LONG POLES (4 FEMALE & 4 MALE)
2. SHORT POLE (FEMALE / FEMALE)
3. METAL STAND
4. FEET (2)
5. PANTS WITH BRACKET
6. HEAD WITH ARMS AND CHAINS
7. MODULE
8. LOCKING PINS
Assemble LONG POLES, 4 MALE to 4 FEMALE (Match Ato A). Twist to lock.
Attach LONG POLES to METAL STAND.
Slide FEET over assembled LONG POLES connected to METAL STAND.
Slide PANTS over assembled LONG POLES connected to METAL STAND.
Attach MODULE to assembled LONG POLES.
Note: MODULE labeled FRONT should be pointing same way as the front of the FEET.
Attach PANTS BRACKET to holes on either end of MODULE, inserting metal prongs
facing down. (See illustration 7)
Attach SHORT POLE to HEAD WITH ARMS AND CHAINS. (Match Bto B) Twist to lock.
Attach opposite end of SHORT POLE to MODULE. (Match Bto B) Twist to lock.
Connect cable located under clothes to cable coming from MODULE. (Match Cto C)
Locate holes in the top of the LONG POLES. Turn the poles and line up holes in top of the LONG POLES
with the holes on MODULE. (Holes are located on MODULE front left and MODULE back
right.) Insert LOCKING PINS as illustrated. (See illustration 6 and 6a)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
FRONT
1 2
34
1. 2. 3. 4. 5. 6. 7. 8.
FEMALE MALE
66a
HOLE
FRONT
7
B
B
8
C
C
10
B
9
B
FRONT MODULE
PAGE 1
A
A
5
FRONT
FRONT

Surface Washable Only.
ALL NEW MATERIALS : PLASTIC,
POLYESTER, POLYESTER FIBER
Battery Powered:
Requires 4 AA Batteries (not included)
Optional DC Adapter Ready (6V 2A)
**DC Adapter and footpad sold
separately and can be purchased
at: www.tekkytoys.com
CONVULSING WEREWOLF is a trademark
of Tekky Toys.
Copyright © 2013 Tekky Toys.
All Rights Reserved.
MADE IN CHINA
Note: Use caution when selecting surface to attach chains.
Adhesive may cause damage to some surfaces.
Use 3M adhesive located on the back of the chain brackets to secure brackets to the desired surface.
Insert 4 AA batteries (not included) into the battery compartment located on the MODULE or
connect 6V 2A adapter. (sold separately)
Pull Convulsing Werewolf’s shirt down so he doesn’t get angry!
Turn switch on top of MODULE to ON to operate in sound & motion activation
mode. Leave switch in OFF position when not in use.
Note:
MIT
ON
OFF
FOOTPAD
FOOTPAD
MODULE
BATTERY
DC 6V. 2A
11.
12.
13.
1. Connect the cable from the optional footpad to the
jack labeled FOOTPAD located on the MODULE.
2. Place the switch on the MODULE into the ‘FOOTPAD’
position to enable FOOTPAD activation.
3. Step on FOOTPAD to activate the scary sequence.
(go to instruction #13 to continue setup)
11
12
4AA
Follow Steps 1 through 12 on initial installation first.
Stay clear of item while operating.
PAGE 2
STOP
visit us at tekkytoys.com
OPTIONAL FOOTPAD SETUP