Lightmybricks LEGO Star Wars Death Star 75159 Lighting Kit User manual

The following page is the instructions for the Light My Bricks LEGO Star Wars
Death Star (75159) LED light kit.
To ensure a trouble-free installation of your light kit, please read and follow
each step carefully.
If you run into any issues, please refer to the online troubleshooting guide.
To download this instructions guide in PDF format please click here.
Please note: This page lists instructions for the LED light kit only. If you are
LIGHT MY BRICKS : LEGO Death Star 75159
Lighting Kit

wishing to purchase the Light My Bricks LEGO Star Wars Death Star (75159)
LED light kit , please click here to view the product page
Package Contents:
13x Green 30cm Bit Lights
7x White 30cm Bit Lights
8x White Strip Lights
4x Blue Strip Lights
2x Red Strip Lights
1x 12-Port Expansion Board
1x 8-Port Expansion Board
5x 6-Port Expansion Boards
2x Multi Effects Boards
4x 5cm Connecting Cables
13x 15cm Connecting Cables
4x 30cm Connecting Cables
1x 50cm Connecting Cables
1x Blue Light My Bricks Lightsaber
1x Red Light My Bricks Lightsaber
1x Green Light My Bricks Lightsaber
1x AA Battery Pack
or
1x USB Power Cable
LEGO Pieces:
2x Trans Dark Blue Round Plate 1×1
4x Trans Bright Green Round Plate 1×1
14x Plate 1×6 (Dark Grey, Light Grey, or Black)

Important things to note:
Laying cables in between and underneath bricks
Cables can fit in between and underneath LEGO® bricks, plates, and tiles
providing they are laid correctly between the LEGO® studs. Do NOT forcefully
join LEGO® together around cables; instead ensure they are laying comfortably
in between each stud.

CAUTION: Forcing LEGO® to connect over a cable can result in
“

Connecting cable connectors to Expansion Boards
Take extra care when inserting connectors to ports of Expansion Boards.
Connectors can be inserted only one way. With the expansion board facing up,
look for the soldered “=” symbol on the left side of the port. The connector side
with the wires exposed should be facing toward the soldered “=” symbol as you
insert into the port. If a plug won’t fit easily into a port connector, do not force it.
damaging the cable and light.

Installing Bit Lights under LEGO® bricks and plates.
When installing Bit Lights under LEGO® pieces, ensure they are placed the
correct way up (Yellow LED component exposed). You can either place them
Incorrectly inserting the connector can can result in bent pins inside
the port or possible overheating of the expansion board when
connected.
“

directly on top of LEGO® studs or in between.

OK, Let’s Begin!
1.) Start by disconnecting the light grey dish piece on the very top of the Death

Star followed by surrounding pieces to allow us to remove the four pillar
sections with trans clear round plates.