Telebrands Pure Magic Spa DTX-08 User manual

13. The series of lights around the perimeter of the
Control Panel illuminate as the treatment progresses.
Each light illuminates for 5 minutes and the total
treatment lasts about 30 minutes.
14. Once 30 minutes are over, a buzzer will sound and
all the lights on the Control Panel will flash a few
times. Your spa will automatically shut off. Your
session is complete. Disassemble the Pure Magic
Spa™, empty out the used water from the tub and
follow the care instructions for cleaning and storing
your Pure Magic Spa™
After Each Use:
1. After you have completed your session, disassemble
the Pure Magic Spa™foot tub and drain the water.
2. Disconnect the Center Array from the Control Panel
by turning the Center Array clockwise and pull apart.
3. Rinse the Center Array with warm water.
Dry thoroughly. Note: After first use, the Center
Array may become discolored. This is normal.
4. Wipe the Control Panel with a damp cloth (do not
immerse in water). Dry thoroughly.
5. Wash the Pure Magic Spa™ foot tub with hot soapy
water. Rinse and dry thoroughly. Do not use any
abrasive materials, cleaning sprays or alcohol
based cleaners.
6. Store the Pure Magic Spa™ in a dry place.
IEPMSIMSYMR0
Technicial Specifications:
Model No.: DTX-08
Voltage: DC 12V, 20W
CAUTION
• Use only the approved supplied electrical adapter. This device
must only be used with the supplied array. DO NOT use alternative
manufactured arrays.
• DO NOT change or remove the array from the foot tub during the
treatment.
• User should NOT undertake repairs themselves. Repairs should
only be conducted by an authorized technician.
• DO NOT immerse the control panel or adapter in water.
• DO NOT use the Pure Magic Spa™ if you are pregnant or nursing.
• DO NOT use the Pure Magic Spa™ if you have epilepsy, have an
organ implant, or have metal implants.
• Children 10 years old and under should not use the Pure Magic
Spa™. Children between 11 and 15 years old should only use the
Pure Magic Spa for 15 minutes under adult supervision.
• Keep away from children at all times and store in a safe place.
• Keep the Pure Magic Spa™ plastic liners away from children.
• Be sure to use a new plastic liner to cover the Pure Magic Spa™
before each use (re-use of bags is not advisable).
• Use clean water for each detoxification session.
Important: Use a new plastic bag to cover the Pure
Magic Spa™ Tub before each use.
Fairfield, NJ 07004
Made in China.
© 2008 International Edge
www.internationaledge.com
PMSpa IM Symbols 5/28/08 4:17 PM Page 1

6. Add 3 mg /0.5 oz. or 1 heaped spoonful (using the
measuring spoon included) of low sodium salt to the
water. The amount of low sodium salt required for the
treatment depends on the hardness of the water in
your area.
7. Place a comfortable chair
near your Pure Magic Spa™.
8. Before putting your feet in the
water, connect the Electrical
Adapter to the top of the
Control Panel (illustration E).
Then, plug in your Pure
Magic Spa™ and turn it on by
pressing the start button.
9. Now, soak your feet in the warm salt water. Make
sure the water level does not reach the top of the
Center Array. Your Pure Magic Spa™ session has now
begun. If the Control Panel buzzes or turns off prema-
turely or the water is too tingly, start the process again
by adding clean water and less low sodium salt.
10. The Pure Magic Spa™ works using the Center Array
which effectively rebalances the body and harmo-
nizes your system. This process helps create natural
stimulation and starts the detoxification process.
11. Once you have started the treatment the first green
light will stay on.
12. After the Pure Magic Spa™ is turned on, you will
start to see tiny bubbles form in the water. The water
will gradually turn color. As the color changes, you
know your Pure Magic Spa™ is working. Various
color changes can occur. The water color can be
light or dark depending on your body type, the hard-
ness of your water and the amount of salt used.
2. Cover the Pure Magic Spa™
tub with one Plastic Spa Liner
provided (illustration A). Always
use a new plastic spa liner to
cover the Pure Magic Spa™
before each use.
3. Insert the Center Array into
the bottom of the Control
Panel (illustration B), and
twist 1/4 turn counter clock-
wise to lock in place (illus-
tration C).
4. Place the Control Panel
on the three prongs on the
Pure Magic Spa™ Tub, and
line up the Center Array in
the center of the tub (illus-
tration D). Make sure it is
secure.
5. Fill the Pure Magic Spa™
with very warm water, 5cm
(2 inches) below the Control
Panel. Do not overfill.
The duration of each treatment is 30 minutes. You can
use the Pure Magic Spa™ once or twice a week.
Instructions for Use:
1. Remove any jewelry that may be damaged before your
Pure Magic Spa™ session.
Congratulations on your purchase of the Pure Magic
Spa™! You’ll benefit from increased vitality, extra energy
and general well being.
Your Personal ‘Pure Magic Spa™’ Includes
the Following:
• Large Size Foot Bath • Plastic Measuring Spoon
• Center Array • 2 Travel Bags
• Control Panel • Electrical Adapter
• 10 Plastic Spa Liners
Illustration A
Illustration C
Tu r n
1/4” to
lock in
place
Illustration B
Illustration D
Illustration E
Large Size
Foot Bath
Center
Array Control
Panel
Plastic Spa Liners Travel Bags
Electrical
Adapter
Power
Button
Plastic
Measuring Spoon
Note: For best results, use the Plastic
Spa Liners that come with your Pure
Magic Spa™, other plastic liners/bags
may break and your Pure Magic
Spa™ may be damaged.
Important: The distributor is not liable
for damage caused by using the Pure
Magic Spa™ incorrectly or by the use
of wrong bags.
PMSpa IM Symbols 5/28/08 4:17 PM Page 2