Telefunken S4400DM User manual

• PALcolor S4400 DM/5400 DM/5400 DM F •
Bedienungs-
anleitung•
Manualedi
utilizzazione•
Manuel
d’utilisation•
User
manual•
Gebruiks-
aanwijzing•
Recto PAL CO 26/06/96 17:13 Page 1

CP.
A
B
AV
PR
SP/LP
ZOOM
0
-/--
1
456
987
0
32
A - Z Z - A
AV
E
D
TV
>>
TV
VCR
-/--
1
456
987
0
32
A
B
A - Z Z - A
RC 1360
E
SP/LP
AV
CD
TV
<< > >>

ZOOM

PR
AV
0
_
_
_
P.
LR 06 - AA LR 06 - A
2 x LR 06 1,5 V.
TELECOMMANDE 26/06/96 18:27 Page 1

GB
television set
safety precautions
3
SAFE USE OF THE EQUIPMENT
10 cm
5 cm 10 cm
10 cm 10 cm
1. TO TURN ON
LEAVE ROOM FOR VENTILATION
AVOID HEAT, WATER, DIRECT
SUNLIGHT.
Do not place audio loudspeakers
near to television. The magnets
in the speakers could cause
patches of colour to appear
on the screen.
To ensure your personal safety and the efficient operation of your
equipment, please follow the advice given below :
Télévision sets need ventilation to avoid overheating which can cause
damage to the components. The ventilation slots at the back of the set
should not be covered up by curtains, small covers, newspapers, etc…
There must be enough room in built-in cabinets to allow for the cooling
air to circulate. The set should not be placed directly next to heating.
This appliance is designed for use in dry areas. If occasionally you
should whish to operate it outdoors (for example, on the balcony or
veranda), you must insure that it is protected against all forms of
moisture (dew, rain, splashed water).
A cold set may be switched on in a warm room only after any
condensation which may happen to be on the screen has evaporated.
Never remove the cabinet back. Have your aerial installed by an
authorised dealer or service technician.
In the evenings, after the TV programmes, or in case of a prolonged
absence, it is recommended that the appliance be switched off using
the main power switch. Even if the ON/OFF switch is in OFF position
the television set is not completely separated from the mains. In order
to separate it completely from the mains, it has to be disconnected by
unplugging the mains plug. Remove the power plug from the wall
outlet under the following conditions :
1. During a thunderstorm. It is also recommended that you disconnect
the aerial plug.
2. If you find a burning smell or smoke emerging from the set.
Additional information :
Your TV set is adequately shielded to prevent emission of X-rays.
The acceleration voltage does not exceed the maximum value of 33 kV.
Work by non-qualified technicians, modification of the high voltage
setting or the replacement of the tube with a model that does not
comply with the manufacturer’s specifications may lead to a
considerable increase in X-ray radiation.
A set changed in any of the above ways no longer satisfies the initial
specifications and should not be put back into service.
2. CARE OF THE EQUIPMENT
3. DEMAGNETISATION
The screen should be cleaned with liquid glass cleaner.
• Never use abrasive cleaners.
• To clean the front and the cabinet of your equipment use a soft cloth dipped in mild detergent. The use of
strong solvents such as white spirits or alcohol based products could damage your equipment.
• Clean the vents on the rear panel of your set regularly.
The earth’s magnetic field may have an effect on your television by causing patches of colour to appear on the
screen. If this happens :
• Switch off the television with the on-off button ;
• Wait a few minutes and then press again to switch on.
This allows the screen to be demagnetised automatically. If patches of colour are still visible repeat the procedure.
The pages of this publication are printed on recycled paper.

PROGRAMME
Set-up - Preferences -
Browse - Clock - Lock -
Tuning - Sound adjustments - AV1 - AV2 - AV3.
SOUND
Loudspeakers - Headphone - AV (Audiovisual).
PICTURE
Picture - PIP - Format.
TELETEXT / TOPTEXT / FASTEXT
PERSONAL ADJUSTMENTS
and scrolling back through the menus.
TO REMOVE THE MENU DISPLAY
or to display programme information, the type of sound
transmission (MONO, STEREO or DUAL),
the programme name and number, the time.
PICTURE FREEZE
ZOOM FUNCTION
TO CALL UP PREVIOUSLY VIEWED PROGRAMME
TO CALL UP ALL PROGRAMMES IN TURN
VOLUME
- Horizontal movement in the menus
- -/+ adjustments of other functions.
Keys 1 to 0 are used to :
- Select the programmes (from 1 to 99)
- Enter the channels numbers
- The 0 key is used to call AV inputs 1, 2 and 3.
MUTE
STAND-BY
REMOTE CONTROL ILLUMINATION
To operate your television set by remote control,
the selector switch TV-VCR must be on TV
position
When a red, green or yellow button is pressed for the first
time, the contents of the menu are displayed at the top of
the screen and the menu of the function selected is
displayed at the bottom of the screen.
Moving horizontally along in the menus
selects the required function on the contents
line if it has not been already selected.
- The selected function is displayed in the same colour as
the button pressed (red, green, yellow).
- The line selected in the menus is displayed in characters
twice as high and in the same colour.
Press the coloured button repeatedly to move down
through the menus selecting different lines.
Make any adjustments.
Changes are saved when you quit the menus, except in
the PROGRAMME menu.
CONNECTIONS AND COMMANDS 5
AUTO-PROGRAMMING 6/8
Switching on - Automatic station search
Programme organiser - New region
INSTALLATION 8/9
Volume limitation - Menu language -
Programme number display - Time reference -
Preferred settings
PICTURE ADJUSTMENTS 10/13
PIP - Format
SOUND ADJUSTMENTS 14/15
Loudspeakers - Headphone - AV
DAY TO DAY OPERATION 16/17
Switching on/Selecting programmes - Browse
OTHER FUNCTIONS - EXTRAS 18/21
Clock - Child lock - Lock
CONNECTIONS 22/24
Units connected - Calling up audiovisual programmes -
TELETEXT 25/27
Calling up Teletext - Options - Alarm - How to select -
Subtitles - New flash
MANUAL PROGRAMMING 28/29
Norm - Decoder - Channel/Cable - Programme - Fine
Tuning - Station name - Store/Erase - Access to the
organiser.
BATTERIES : Refer to page 24 for the fitting of the batteries
contents
remote control
functions
remote control
using
CP.
A
B
AV
PR
SP/LP
ZOOM
0
-/--
1
456
987
0
32
A - Z Z - A
AV
E
D
TV
>>

television set
connections and commands
5
VIDEO L AUDIO R
INSTAL
STATUS
PR +
PR -
+
-
On/Standby light:
Green : on
Red : Stand-By On / Off switch
Volume adjustments Display
Programme
Selection Installation- 
menu
Video and audio sockets

S-Video and 
audio sockets
Headphone socket 
Ø 6,35 mm
AV3
AV3
Connect to AC main supply 
220-240 V~50 Hz
HiFi Amplifier
AV 2 AV 1
Ψ75
(OUT L)
(OUT R)
Camcorder
S-Video Video Audio
(IN)
(OUT)
Aerial *
Main loudspeakers
Video recorder
Video recorder
Decoder Video games consoleCDV player
Satellite receiver
Camcorder
Camcorder
Surround loudspeakers
S-VHS
Hi-8 mm or VHS
8 mm
AV1
AV2
AV2
ON THE FRONT AND AT THE RIGHT SIDE OF THE SET
AT THE BACK OF THE SET
For further details,
see page 22.
GB
*We recommend that you use an aerial cable with double isolation.