TeleWell TW-EAV510 AC v2 User manual

TW-EAV510 Wireless Bridge (WDS)
Configuration Guide
Step:
1. Device 1 and Device 2’s LAN IP address must be different and can be
in the same subnet.
Device 1 with DHCP Server enabled
Advanced Setup -> LAN -> LAN Setting

Device 2 with DHCP Server disabled
Advanced Setup -> LAN -> LAN Setting
The DHCP server should only be enabled on one of device in order to prevent any
conflict.
2. The SSID name for Device 1 and Device 2 can be different.
Device 1: Wireless -> Basic
Device 2: Wireless -> Basic
3. The Wireless security setting can only be WEP 64/128bit for Wireless
Bridge (WDS) connection.

Device 1: Wireless -> Security
Device 2: Wireless -> Security
Note: The throughput between Device 1 and Device 2 can only up to 54Mbps due to
WEP standard limitation.
4. The wireless channel for Wireless Bridge (WDS) must be fixed and use
the same channel on both Device 1 and Device 2 to make connection
stable.
Device 1 and Device 2: Wireless -> Advanced

5. Enable the Wireless Bridge and setup the remote bridges MAC
address.
Device 1: Wireless -> Wireless Bridge
Device 2: Wireless -> Wireless Bridge
Note: If you also need share wireless to clients, the AP Mode must set to Access
Point. And can follow the step below.
6. The SSID for Wireless Bridge can only be used for WDS connection and not allow
other clients to connect. In case, you can just enable the Wireless Guest/Virtual
Access Points.

Device 1 and Device 2: Wireless -> Basic
Note:
1. It is better that SSID for Virtual Access Point is different on both Device 1 and
Device 2.
2. Please go to Wireless -> Security to enable the security if the security is needed.