Testrite Visual Privacy Stand PVC3 User manual

Privacy Stand™ Applicable Products:
PVC3
PVC3C
PVC4
PVC4C
1. Attach stand-o to base using the screw provided.
2. Slide banners over crossbars.
3. Connect end uprights and lower crossbars to the stand-o
4. Connect internal uprights and lower crossbars to the stand-o.
5. Connect end upper crossbar to upright using the knob screw provided.
6. Connect internal upper crossbar to upright using the knob screw provided.
NOTE: Model shown below may dier in height and width from your model, but assembly instructions remain the same.
1. 2.
5. 6.
4.
3.
PVC3 Shown

Privacy Stand™ Applicable Products:
PVC5
PVC5C
PVC6
PVC6C
1. Attach the lower upright to the base, using the screw provided
2. Connect the upper upright to the lower upright.
3. Connect the snap-on clip to the uprights.
4. Attach the graphic.
1. 2.
4.
3.
PVC5 Shown