Teufel Raumfeld M Stands User manual

Quickstart Guide
Raumfeld M Stands
EN

1 Unboxing 2 Assembly
Welcome to Raumfeld
Take a moment to check that all components shown
below were included with your delivery.
Before you start using this product, please read the
safety instructions carefully.
Please keep the box for the duration
of the warrantee period.
Lay the power and speaker
cables through the stand’s
column and out through the
cable opening on the upper
side.
Now place the loudspeaker
with the adapter plate
attached onto the stand’s
column. Use the three screws
included with delivery to
rmly connect the stand to
the loudspeaker.
Begin by attaching the base
to the column using the four
identical screws included with
delivery for this purpose.
Note: The cable routing from
the top of the base and upper
end of the column must be
facing the back side of the
stand.
You may now attach the
adapter plate for connecting
the stand to the bottom of
the Raumfeld loudspeaker.
Use the screws included with
delivery for this purpose.
Note: The at side of the
round adapter plate must
face the back side of the
loudspeaker.
12
3 4
2 x

Contact
RF-M-Stands-v.2.3-EN
If you have any product related questions, need product
support or have suggestions, please contact us at:
Europe
Email / [email protected]
Telephone
DE /CH /AT [phone]
NL [phone]
DK [phone]
SE [phone]
FI [phone]
NOR [phone]
GB [phone]
Other countries within the delivery area (English spoken)
00800 200 300 40
USA
Email / [email protected]
Telephone / + 1 888 98 31 276 (toll free)
Raumfeld® is a registered trademark of Lautsprecher Teufel
GmbH, used under licence. All rights reserved. Images may
vary slightly from the actual products.
In the United States, Raumfeld products are sold and distri-
buted by Berlin Acoustics, Inc., a Delaware corporation, and
its authorized agents.
Outside the United States, please contact:
Lautsprecher Teufel GmbH
BIKINI Berlin
Budapester Strasse 44
10787 Berlin – Germany
www.raumfeld.com