The Human Solution Neutral Posture User manual

Assembly Guide
08/2012 © 2010 Neutral Posture, Inc. All rights reserved.
Tools ⁄" Allen wrench (provided)
People 1 Person
Time 5 - 10 minutes
Neutral Posture® Seating
Press casters rmly into
base until they are securely
snapped into place.
Install arms.
See arm installation on back.
Insert cylinder into base.
Lift seat/mechanism assembly
and t onto cylinder. Ensure
mechanism is secure on
cylinder by sitting on the seat.
Lift by the seat, not the armrests.
Place back post into
mechanism stub and
tighten all bolts with
Allen-wrench.
Slip on the cylinder
cover if available.
1
6
2
4
5
3

08/2012 © 2011 Neutral Posture, Inc. All rights reserved.
Place screws in the spaces
under the bottom lip and
combine w/ upper section.
Slide headrest onto
back of chair.
Tighten screws using Phillips Screw
Driver until headrest is secured on the
back of the chair.
1
2
3
Tools Phillips Screw Driver
People 1 Person
Time 5 – 10 minutes
Tools Allen wrench (included) or 10mm Socket
People 1 Person
Time 8 - 10 minutes
H5 Headrest
NP 360°Arm
Turn chair upside down
on work surface for access
to the arm brackets.
Remove the lever release hardware
using the allen wrench or 10mm
socket. Do not remove tape that
secures the hardware together, until
after nal step of installation.
5
4
Place onto mounting pin.
Place onto mounting pin.
Bevelled side should be facing up.
Align the arm onto plastic
guide tray.
Button should be facing
towards backrest.
Place inside the lever.
Flat surface should be facing up.
Place onto mounting pin.
Slightly tighten nut. Lift lever
and continue to tighten until
proper tension is reached.
Proper tension allows arms to lock
into position and adjust freely
when unlocked.
1
3
2
6
The new NP 5-way arms will only install on a chair
mechanism with the arm brackets shown, and
will not retrot older Neutral Posture chairs.
Installation Guide
Preparation Guide