ThermoWorks Smoke X4 User manual

What’s Included:
Smoke X4 Receiver, Batteries (Installed), neck lanyard, and this
instruction card.
How to Operate:
• To power Smoke X4 Receiver on, press the button.
• To activate backlight, press the button.
• To power Smoke X4 Receiver off, press and hold for 3
seconds.
• To change volume level, press VOL button.
• To mute an alarm, press any button.
How to sync:
• With Smoke X4 powered on, press and hold the button
for 5 seconds until “SYNC” appears on the screen.
• Now that Smoke X4 is in SYNC mode, make sure Smoke X4
Receiver is powered on.
• Press and hold the VOL button for 5 seconds on Smoke
X4 Receiver. The display should read “SYNC” for a short
amount of time.
• Both Smoke X4 and Smoke X4 Receiver will beep and
return to normal functionality signaling a successful pairing.
NOTE: To sync multiple Smoke X4 Receivers to one base,
please follow the steps above on one Smoke X4 Receiver at
a time. Putting Smoke X4 into Sync mode will not disable or
interfere with previously synced Smoke X4 Receivers.
Go to www.thermoworks.com/smokex for additional product
information and more tips for use.
Smoke X4™Receiver
Operating Instructions
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Special Notice
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
P-18-09-02-b
www.thermoworks.com
741 E. Utah Valley Dr.
American Fork, UT 84003
For service or warranty:
1-800-393-6434
1-801-756-7705
[email protected]

Transmission / Sync button
(Smoke X4)
Indicates wireless
transmission is on, flashes
when transmission is active
(patent pending).
Battery life indicator.
Smoke X4 Receiver display
updates every 30 seconds
with live temperatures
from Smoke X4. It will also
show the High/Low Alarm
temperature settings and if
the alarm is on or off.
Changes alarm volume
setting or mutes alarm.
Press to turn on Smoke X4
Receiver, mute alarm, and
to enable backlight for 20
seconds. Press and hold for
3 seconds to turn Smoke X4
Receiver off.