Thor’s Drone World LIFTHOR SC PRO ENTERPRISE COMBO User manual

by Thor’s Drone World
User’s Manual

Congratulations
on your new
Utility mount for
DJI Smart Controller
ENTERPRISE

Utility Mount
Content:
Tablet clamp
Compatible with 7.9” up to
13” devices
HDMI Cable
Hex Key
COMBO
Tablet
Mount
Screwdriver
Screws

Tablet Mount
- Tablet Mount
- Tablet Clamp
- 4x Screws (M2.5 x 8)
- Screwdriver
- Hex Key (Allen Key)
- 3x USB 2.0 ConnecThor Cables (Lightning / Type C / Micro USB)

Utility Mount
- Utility Mount
- 4x Screws (M2.5 x 8)
- 1x Screw (1/4”-20 x 3/8”)
- Screwdriver
- Hex Key (Allen Key)
- HDMI ConnecThor Cables

How to assemble:
Remove the protective sticker
from your Smart Controller to
accesses the screw points
Utility Mount

Align the mount with your Smart Controller to secure it in
place with the (4x) screws provided .

To have better access of the rear screws
adjust the angle of the top bracket

Now your utility mount is properly installed!

To install an HDMI Monitor, adjust the top bracket to
have easy access to align it with the monitor’s mounting
point . With the screw provided and the use of the hex
key (Allen key) secure it in place

Adjust the position of the monitor, accordingly , use the
hex key to tighten it in place. You can use a small wrench
tool #8 (not provided) to give it an extra tight.

Connect your monitor with the HDMI
ConnecThor Cable included - to your
DJI Smart Controller.

There you go,
now you are ready for takeoff.

How to assemble:
Tablet Mount

Align the mount with your Smart Controller to secure it in
place with the (4x) screws provided .

Unscrew the tightening ring from the back of the
Tablet Clamp and place it on the ball joint
tightening
ring

Attach the clamp to the ball
joint and screw the ring back to
secure the clamp position /
angle.
tightening ring

The clamp has two
mechanisms to ensure
your tablet sit secure
and in place.
The first mechanism is
the ratchet part, to
adjust to the size of your
tablet. We recommend
setting it a little smaller
(1” / 2.5cm) than the
actual size of the tablet
for a tighter, secure fit.
Once you have
selected the right height
lock the ratchet in place
by sliding the lock
downwards.

Lock

Place the tablet in landscape mode by pulling the spring
mechanism upwards and release it to secure the tablet in place.
You can adjust the top clamp tabs, if needed, to avoid pressing
on any buttons
*Scan the QR code
with your phone for a
video tutorial

Scan the QR code, by
opening the camera
app on your smart
phone or tablet
device.
Point your camera at
the QR code.
Tap the banner that
appears on your
device to open the
tutorial video in
YouTube