Thor’s Drone World TRIPLTEK LIFTHOR LITE User manual

by Thor’s Drone World
User’s Manual
LITE
TRIPLTEK mount for
Phantom 4 / Inspire / Agras

Congratulations
on your new
LITE
the Ultimate Tablet holder for
DJI Phantom / DJI Inspire / DJI Agras

Mounting
bracket
Content:
Tablet clamp
Compatible with 7.9” up to
13” devices
Hex Key (x2)
Screws (x2)
& washer
Additional tools needed:
-Flat Screwdriver

How to assemble:
Remove the OEM bracket from the Remote control
with the help of a screwdriver. (not included)

With the tips of your fingers unscrew the rear
support of the bracket to remove the OEM
bracket.

Align the LifThor Lite mounting bracket and secure
lightly with the smaller screw with the smaller Hex
Key (Allen key) provided

Secure the rear end of the bracket with the bigger
screw and washer provided, once secured in place
tighten the front screw by pushing down the
bracket to align properly.

Unscrew the tightening ring from the back of the
tablet clamp and place it on the ball joint
tightening
ring 

Attach the clamp to the ball joint and screw the
ring back to secure the clamp position / angle.
tightening ring

The clamp has two
mechanisms to ensure
your tablet sit secure
and in place.
The first mechanism is
the ratchet part, to
adjust to the size of your
tablet. We recommend
setting it a little smaller
(1” / 2.5cm) than the
actual size of the table
for a tighter, secure fit.
Once you have
selected the right height
lock the ratchet in place
by sliding the lock
downwards.

Ratchet part
to adjust the
height

Lock

Place the tablet
in landscape
mode by
pulling the
spring
mechanism
upwards and
release it to
secure the
tablet in place.
You can adjust
the top clamp
brackets, if
needed, to
avoid pressing
on any buttons
*Scan the QR code
with your phone
for a video tutorial

All set!
Enjoy your flight!

www.lifthor.com