Thunderbook Atlas W115 Instruction manual

ATLAS W115
QUIck user’S GUIDE

2
TABLE OF CONTENTS
PackageContents......................................................................................3
SafetyInstructions.....................................................................................4
Device Description.....................................................................................8
Replacing the battery...............................................................................10
Inserting SIM y Micro-SD Cards.............................................................12
Congure programmable buttons...........................................................14

EN
3
Check your product box for the following items:
• Rugged Tablet Atlas W115
• Stylus pen
• Crystal clean cloth
• DC-Jack Charger 220VAC
This device is in compliance with the essential safety
requirements and other relevant provisions set out in the
European Directive.
Package contents
Package contents

4
SAFETY INSTRUCTIONS
Batteries:
Batteries are parts whose life cycle depends on handling. If no failure
is reported within 3 months after receipt of the equipment, the battery
will be considered to be functioning properly. Failure to comply with
these regulations will lead to the loss of guarantee.
Please note the following:
• Fully charge the battery every three months.
• Do not work with the device at less than 20% battery as it may
damage the battery. The device will not come under warranty if it is
detected that the battery is at 0% charge.
• The LED indicator on the front of the tablet should blink during
charging. If not, it is due to a battery failure.
• Before working in negative temperatures, make sure the battery is
85% charged or higher.
• In negative temperatures do not work with the equipment with a
load below 60%.
• The battery charge temperature is 0ºC to 40ºC.
• The storage temperature of the battery is between 0ºC and 25ºC.
Charge the battery (or equipment) before storing it.
• Avoid exposing the device or battery to high temperatures.
• Do not overcharge the battery. The full charge is indicated when the
indicator LED stops flashing.
Warning: Please read and observe carefully before using the device!

EN
5
• Do not expose the battery to mechanical stress.
• Do not damage the batteries with sharp or pointed objects.
• Do not throw batteries into re - they may explode.
• Do not throw liquids on the batteries.
• Avoid short-circuiting the batteries, as it can lead to overheating
and ignition of the battery.
• If liquid comes out of the battery and comes into contact with
eyes or skin, rinse immediately with clean water and seek medical
attention.
• Incorrect battery replacement may cause a risk of explosion.
• Replace the battery only with the same or equivalent recommended
by the manufacturer.
• Batteries should not be disposed of with normal household waste.
Use the service of specialized stores that perform recycling.

6
Environment:
Protect the device from temperatures outside the specied range. The
device is protected against spray water but must not be submerged
in water or be exposed to water jets. Do not expose the unit to strong
magnetic elds or strong static electricity. Once water or liquid has
entered the unit, turn it off and do not use until it is dried. Have it
checked by a qualied specialist.
Safety in operation:
Do not drop the device. Do not bend or twist it. This may result in a
breakage of the display glass or of circuit boards and mechanical
parts. To avoid hearing damage, listen to music via headphones at
a moderate volume and never place the speaker outputs directly in
front of your ear. Keep packaging materials and small parts away
from children. There is a danger of suffocation. Never open the case
of the appliance or the charger (risk ofelectric shock, short-circuit and
re). Do not put objects through slots or openings on the appliance or
charger (risk of electric shock, short circuit, and re). Do not attempt
to open the unit, the unit may be destroyed and you will lose warranty.
SAFETY INSTRUCTIONS

EN
7
Cleaning:
Never clean the surface of the appliance with solvents, detergents or
other chemical products. Use a soft, dry cloth instead.
Power supply:
Always use the original charger or one with suitable current and
voltage rating to prevent damage to the device. If you use an universal
charger, consider the polarity of the charger as well as the current and
the voltage rating. Do not unplug the charger from the wall outlet by
pulling the cable. Do not use chargers with damaged cables or plugs.
Disposal:
Dispose used electronic equipment at the appropriate collection
points. Please note that your device has a battery and therefore it
must not be disposed with normal household waste. Please consult
your local or municipal authorities for the correct disposal route of
your device and battery.

8
2
1
3
4
5
DEVICE DESCRIPTION
3
2
1
4
5
2MP camera
Status LEDs
Power
Programmable Keys
Brightness / Volume Adjustment

EN
9
17
20
21
9
8
7
6
10
11
12
13 14 15 16
18
19
HDMI (D.P. optional)
USB 3.0
SIM Card
Mic / Headset combo jack
6
7
8
9
DC-IN
RJ-45
Micro SD
Quick release SSD
10
11
12
13
14
15
16
17
Kensington lock
SmartCard / CAC reader
Hot swappable battery pack
Docking connector
18
19
20
21

10
Remove the battery
1. Press the button and slide the latch to the right to unlock the
battery as shown in the image
2. Remove the battery with the help of the grip (located to the right of
the battery block).
Attention
Removing the battery while the tablet is still on will start the
consumption of the secondary battery whose duration is 5 minutes.
We recommend putting the tablet in suspension.
12
Removing the battery

EN
11
Insert the battery
1. Insert the battery from the contact side.
2. Push down the opposite side slightly and slide the locking latches
by pressing its respective button.
1
2
INSERTING THE BATTERY

12
Attention:
Your device may not have 4G Modem, depending on the conguration
acquired.
Inserting the mini SIM card
The slot accepts only mini SIM cards. Insert the card into the SIM slot
like shown in the picture on the next page.
Inserting a SD card
Insert the micro SD card into SD card slot.
Closing
Close the rubber cover properly to ensure the device’s IP protection.
Inserting SIM & Micro-SD cards
Tip:
For the SIM card, a Pin number may be requested. Enter the SIM card
pin number and tap OK.

EN
13
SIM

14
configurar botones programables
Attention:
It may be necessary to deactivate the tablet mode In order to view
background applications.
Background applications
Access the background applications section of Windows 10.
Open app
Open the “Quick menu” application (image 14.1).
Congure buttons
Once the menu is opened (image 14.2), you can congure the P1 /
P2 buttons as well as the “Up” and “Down” buttons, displaying their
respective submenus.
Image 14.1

EN
15
Image 14.2

Av. Corts Catalanes, 5-7
08173 - Sant Cugat del Valles
Barcelona - Spain
https://www.thunderbook.eu