Tibor LIGHT Back Country CL Wide User manual
CLEANING & MAINTENANCE
Tibor Light® reels require virtually no maintenance.
Occasionally, a few drops of TiborLubeTM should be
applied to the ConstaLubeTM Felt. If sand or dirt gets
into the reel, simply remove the Spool, ush with
fresh water and reinstall the Spool. Aside from the
Drag Felt, there is nothing on the reel to lubricate.
Periodically, especially after extensive exposure to
saltwater, the line and backing should be removed
and wiped down with a wet cloth to remove salt.
When the reel, line and backing are completely dry,
the reel should be stored in its protective pouch.
Please note: Exceeding the recommended
capacity by over-lling the Spool and/or putting
line on too tightly or with too much tension may
damage the Spool and is not covered under
warranty. Please refer to this capacity chart as
your basic guide:
Back Country CL Wide: 6/275 7/250 8/225 9/200
with 20 lb. Micron
CONVERSION FROM RIGHT TO
LEFT HAND RETRIEVE
Tibor Light reels are shipped from the factory with
left hand retrieve unless specied. An authorized
dealer can easily convert your Tibor Light CL reel
from left to right hand retrieve for you. You may
also convert the reel yourself in three easy steps
by rotating the Clutch Pins on the Brake Drum.
Please refer to the numbered parts list on the
reverse side.
1. Begin by tightening the Drag Adjustment
Screw (part #7); then loosen the Retainer Knob
(part #17) and remove the Spool (part #14).
2. Using a small screwdriver, simply press and
rotate both Clutch Pins (part #12) 180˚ so
that the “slope”of the Pins faces the opposite
direction.
3. Replace the Spool and tighten the Retainer Knob.
TIbOR LIGHT®: Back Country CL Wide Model
All replacement parts are available though your local
Tibor dealer. A selection of replacement parts is also
available for purchase online at tiborreel.com.
When ordering parts, please specify color, model, part
name and part number.
TIbOR LIGHT®: Back Country CL Wide Model
Ref.# Part Name Part#
1 Reel Stand Screw LCP-1
2 Reel Stand BC-2
3 Frame BCW-3
4 Drag Brake Caliper BC-4
5 Drag Adjustment Block TL-5
6 Stop Nut TL-6
7 Drag Adjustment Screw BC-7
8 Drag Spring BC-8
9 Out-Going Clicker Ball LCP-9
10 Out-Going Clicker Spring LCP-10
11 Clutch Spring LCP-11
12 Easy Change Clutch Pin TL-12
13 Counter Weight Screw LCP-13
14 Spool BCW-14
Ref.# Part Name Part#
15 Counter Weight TL-15
16 Two Ball Bearings LCP-16
17 Retainer Knob TL-17
18 Main Shaft Screw LCP-18
19 Main Shaft BCW-19
20 Retainer Plate Screws LCP-20
21 Brake Drum Cover BC-21
22 Brake Drum BC-22
23 Handle Knob Screw LCP-23
24 O-Ring LCP-24
25 Handle Knob Seat TL-25
26 Handle Knob TL-26
27 Handle Knob Shoulder Screw TL-27
28 ConstaLube Felt BCW-32
1
2
3
45
6
78
910
11 12
13
14
15
16
17
18 19 20
21 22
23
24 25
26
27
28
Other Tibor Cables And Connectors manuals
